From: Philip Avinash <avinashphilip@ti.com>
To: nsekhar@ti.com, khilman@deeprootsystems.com,
linux@arm.linux.org.uk, grant.likely@secretlab.ca,
linus.walleij@linaro.org
Cc: linux-arm-kernel@lists.infradead.org,
davinci-linux-open-source@linux.davincidsp.com,
linux-kernel@vger.kernel.org, KV Sujith <sujithkv@ti.com>,
Rob Herring <rob.herring@calxeda.com>,
Rob Landley <rob@landley.net>,
devicetree-discuss@lists.ozlabs.org, linux-doc@vger.kernel.org,
Philip Avinash <avinashphilip@ti.com>
Subject: [PATCH 09/11] gpio: davinci: DT changes for driver
Date: Wed, 22 May 2013 12:40:32 +0530 [thread overview]
Message-ID: <1369206634-6778-10-git-send-email-avinashphilip@ti.com> (raw)
In-Reply-To: <1369206634-6778-1-git-send-email-avinashphilip@ti.com>
From: KV Sujith <sujithkv@ti.com>
- Add of_device_id for Davinci GPIO driver.
- Add function to populate data from DT.
- Modify the probe to read from DT if DT match is found.
- Add DT binding documentation for Davinci GPIO properties in a new file
gpio-davinci.txt located at Documentation/devicetree/bindings/gpio/.
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Rob Herring <rob.herring@calxeda.com>
Cc: Rob Landley <rob@landley.net>
Cc: devicetree-discuss@lists.ozlabs.org
Cc: linux-doc@vger.kernel.org
Signed-off-by: KV Sujith <sujithkv@ti.com>
Signed-off-by: Philip Avinash <avinashphilip@ti.com>
---
.../devicetree/bindings/gpio/gpio-davinci.txt | 26 +++++++++
drivers/gpio/gpio-davinci.c | 57 ++++++++++++++++++--
2 files changed, 80 insertions(+), 3 deletions(-)
create mode 100644 Documentation/devicetree/bindings/gpio/gpio-davinci.txt
diff --git a/Documentation/devicetree/bindings/gpio/gpio-davinci.txt b/Documentation/devicetree/bindings/gpio/gpio-davinci.txt
new file mode 100644
index 0000000..0d599d9
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-davinci.txt
@@ -0,0 +1,26 @@
+Davinci GPIO controller bindings
+
+Required Properties:
+- compatible:"ti,da830-gpio"
+
+- reg: Physical base address of the controller and length of memory mapped
+ region.
+
+- interrupts: The Starting IRQ number for GPIO
+
+- ngpio: The number of GPIO pins supported
+
+- intc_irq_num: The number of IRQs supported by the Interrupt Controller
+
+- gpio_unbanked: The number of GPIOs that have an individual interrupt
+ line to processor.
+
+Example:
+gpio: gpio@1e26000 {
+ compatible = "ti,da830-gpio";
+ reg = <0x226000 0x1000>;
+ interrupts = <42>;
+ ngpio = <144>;
+ intc_irq_num = <101>;
+ gpio_unbanked = <0>;
+};
diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
index 08830aa..dbe3b83 100644
--- a/drivers/gpio/gpio-davinci.c
+++ b/drivers/gpio/gpio-davinci.c
@@ -19,6 +19,8 @@
#include <linux/irqdomain.h>
#include <linux/kernel.h>
#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
#include <linux/platform_device.h>
#include <linux/platform_data/gpio-davinci.h>
#include <mach/gpio-davinci.h>
@@ -133,6 +135,50 @@ static void davinci_gpio_set(struct gpio_chip *chip, unsigned offset,
__raw_writel((1 << offset), value ? ®s->set_data : ®s->clr_data);
}
+static struct davinci_gpio_platform_data *davinci_gpio_set_pdata_of(
+ struct platform_device *pdev)
+{
+ struct device_node *dn = pdev->dev.of_node;
+ struct davinci_gpio_platform_data *pdata;
+ u32 val, ret;
+
+ pdata = devm_kzalloc(&pdev->dev, sizeof(*pdata), GFP_KERNEL);
+ if (pdata) {
+ ret = of_property_read_u32(dn, "ngpio", &val);
+ if (ret)
+ goto of_err;
+
+ pdata->ngpio = val;
+
+ ret = of_property_read_u32(dn, "gpio_unbanked", &val);
+ if (ret)
+ goto of_err;
+
+ pdata->gpio_unbanked = val;
+
+ ret = of_property_read_u32(dn, "intc_irq_num", &val);
+ if (ret)
+ goto of_err;
+
+ pdata->intc_irq_num = val;
+ }
+
+ return pdata;
+
+of_err:
+ dev_err(&pdev->dev, "Populating pdata from DT failed: err %d\n", ret);
+ return NULL;
+}
+
+static const struct of_device_id davinci_gpio_ids[] = {
+ {
+ .compatible = "ti,da830-gpio",
+ },
+ { },
+};
+
+MODULE_DEVICE_TABLE(of, davinci_gpio_ids);
+
static int davinci_gpio_probe(struct platform_device *pdev)
{
int i, base;
@@ -142,13 +188,17 @@ static int davinci_gpio_probe(struct platform_device *pdev)
struct davinci_gpio_regs *regs;
struct device *dev = &pdev->dev;
struct resource *res;
+ const struct of_device_id *match =
+ of_match_device(of_match_ptr(davinci_gpio_ids), &pdev->dev);
- pdata = dev->platform_data;
+ pdata = match ? davinci_gpio_set_pdata_of(pdev) : dev->platform_data;
if (!pdata) {
dev_err(dev, "GPIO: No Platform Data Supplied\n");
return -EINVAL;
}
+ dev->platform_data = pdata;
+
/*
* The gpio banks conceptually expose a segmented bitmap,
* and "ngpio" is one more than the largest zero-based
@@ -490,8 +540,9 @@ done:
static struct platform_driver davinci_gpio_driver = {
.probe = davinci_gpio_probe,
.driver = {
- .name = "davinci_gpio",
- .owner = THIS_MODULE,
+ .name = "davinci_gpio",
+ .owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(davinci_gpio_ids),
},
};
--
1.7.9.5
next parent reply other threads:[~2013-05-22 7:10 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <1369206634-6778-1-git-send-email-avinashphilip@ti.com>
2013-05-22 7:10 ` Philip Avinash [this message]
2013-05-30 18:25 ` [PATCH 09/11] gpio: davinci: DT changes for driver Linus Walleij
[not found] ` <CACRpkdZH4w_-K617QNCo0Z9jH7LKQyjzoG9K-dj4UbN3h5Bcxw-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2013-06-10 11:45 ` Philip, Avinash
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1369206634-6778-10-git-send-email-avinashphilip@ti.com \
--to=avinashphilip@ti.com \
--cc=davinci-linux-open-source@linux.davincidsp.com \
--cc=devicetree-discuss@lists.ozlabs.org \
--cc=grant.likely@secretlab.ca \
--cc=khilman@deeprootsystems.com \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=nsekhar@ti.com \
--cc=rob.herring@calxeda.com \
--cc=rob@landley.net \
--cc=sujithkv@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).