From mboxrd@z Thu Jan 1 00:00:00 1970 From: Sebastian Reichel Subject: [RFCv4 05/11] Documentation: DT: omap-ssi binding documentation Date: Mon, 16 Dec 2013 00:27:58 +0100 Message-ID: <1387150085-23173-6-git-send-email-sre@debian.org> References: <1387150085-23173-1-git-send-email-sre@debian.org> Return-path: In-Reply-To: <1387150085-23173-1-git-send-email-sre@debian.org> Sender: linux-omap-owner@vger.kernel.org To: Sebastian Reichel , Linus Walleij , Shubhrajyoti Datta , Carlos Chinea Cc: Tony Lindgren , Grant Likely , Rob Herring , Pawel Moll , Mark Rutland , Stephen Warren , Ian Campbell , Rob Landley , =?UTF-8?q?=27Beno=C3=AEt=20Cousson=27?= , devicetree@vger.kernel.org, linux-kernel@vger.kernel.org, linux-omap@vger.kernel.org, =?UTF-8?q?Pali=20Roh=C3=A1r?= , =?UTF-8?q?=D0=98=D0=B2=D0=B0=D0=B9=D0=BB=D0=BE=20=D0=94=D0=B8=D0=BC=D0=B8=D1=82=D1=80=D0=BE=D0=B2?= , Joni Lapilainen , Aaro Koskinen , Sebastian Reichel List-Id: devicetree@vger.kernel.org Create device tree binding documentation for OMAP Synchronous Serial Interface (SSI) device. Signed-off-by: Sebastian Reichel --- Documentation/devicetree/bindings/hsi/omap_ssi.txt | 69 ++++++++++++++++++++++ 1 file changed, 69 insertions(+) create mode 100644 Documentation/devicetree/bindings/hsi/omap_ssi.txt diff --git a/Documentation/devicetree/bindings/hsi/omap_ssi.txt b/Documentation/devicetree/bindings/hsi/omap_ssi.txt new file mode 100644 index 0000000..0a9efd8 --- /dev/null +++ b/Documentation/devicetree/bindings/hsi/omap_ssi.txt @@ -0,0 +1,69 @@ +OMAP SSI controller bindings + +Required properties: +- compatible: Should include "ti,omap3-ssi". +- reg-names: Contains the values "sys" and "gdd". +- reg: Contains a register specifier for each entry in + reg-names. +- interrupt-names: Contains the value "gdd_mpu". +- interrupts: Contains interrupt information for each entry in + interrupt-names. +- ranges Represents the bus address mapping between the main + controller node and the child nodes below. +- #address-cells Should be set to <1> +- #size-cells Should be set to <1> + +Each port is represented as a sub-node of the ti,omap3-ssi device. + +Required Port sub-node properties: +- compatible: Should be set to the following value + ti,omap3-ssi-port (applicable to OMAP34xx devices) +- reg-names: Contains the values "rx" and "tx". +- reg: Contains a register specifier for each entry in + reg-names. +- interrupt-parent Should be a phandle for the interrupt controller +- interrupt-names: Contains the values "mpu_irq0" and "mpu_irq1". +- interrupts: Contains interrupt information for each entry in + interrupt-names. +- ti,ssi-cawake-gpio: Defines which GPIO pin is used to signify CAWAKE + events for the port. This is an optional board-specific + property. If it's missing the port will not be + enabled. + +Example for Nokia N900: + +ssi-controller@48058000 { + compatible = "ti,omap3-ssi"; + + /* needed until hwmod is updated to use the compatible string */ + ti,hwmods = "ssi"; + + reg = <0x48058000 0x1000>, + <0x48059000 0x1000>; + reg-names = "sys", + "gdd"; + + interrupts = <55>; + interrupt-names = "gdd_mpu"; + + #address-cells = <1>; + #size-cells = <1>; + ranges; + + ssi-port@0 { + compatible = "ti,omap3-ssi-port"; + + reg = <0x4805a000 0x800>, + <0x4805a800 0x800>; + reg-names = "tx", + "rx"; + + interrupt-parent = <&intc>; + interrupts = <51>, + <52>; + interrupt-names = "mpu_irq0", + "mpu_irq1"; + + ti,ssi-cawake-gpio = <&gpio5 23 GPIO_ACTIVE_HIGH>; /* 151 */ + } +} -- 1.8.5.1