Re: [PATCH v2 1/2] i2c: qup: Add device tree bindings information

["Ivan T. Ivanov" <iivanov@mm-sol.com>]

Thanks Bjorn, 

I have prepared second version, but never send it out :-).
One thing suggested by Mark was missed in this version.


On Mon, 2014-01-13 at 16:30 -0800, Bjorn Andersson wrote: 
> From: "Ivan T. Ivanov" <iivanov@mm-sol.com>
> 
> The Qualcomm Universal Peripherial (QUP) wraps I2C mini-core and
> provide input and output FIFO's for it. I2C controller can operate
> as master with supported bus speeds of 100Kbps and 400Kbps.
> 
> Signed-off-by: Ivan T. Ivanov <iivanov@mm-sol.com>
> [bjorn: reformulated part of binding description and cleaned up example]
> Signed-off-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
> ---
>  .../devicetree/bindings/i2c/qcom,i2c-qup.txt       | 41 ++++++++++++++++++++++
>  1 file changed, 41 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/i2c/qcom,i2c-qup.txt
> 
> diff --git a/Documentation/devicetree/bindings/i2c/qcom,i2c-qup.txt b/Documentation/devicetree/bindings/i2c/qcom,i2c-qup.txt
> new file mode 100644
> index 0000000..a99711b
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/i2c/qcom,i2c-qup.txt
> @@ -0,0 +1,41 @@
> +Qualcomm Universal Peripheral (QUP) I2C controller
> +
> +Required properties:
> + - compatible: Should be "qcom,i2c-qup".
> + - reg: Should contain QUP register address and length.
> + - interrupts: Should contain I2C interrupt.
> +
> + - clocks: Should contain the core clock and the AHB clock.

+ - clocks: a list of phandle + clock-specifier pairs for each entry in
+           clock-names

> + - clock-names: Should be "core" for the core clock and "iface" for the
> +                AHB clock.
> +
> + - #address-cells: Should be <1> Address cells for i2c device address
> + - #size-cells: Should be <0> as i2c addresses have no size component
> +
> +Optional properties:
> + - clock-frequency: Should specify the desired i2c bus clock frequency in Hz,
> +                    default is 100kHz if omitted.
> +
> +Child nodes should conform to i2c bus binding.
> +
> +Example:
> +
> + i2c2: i2c@f9924000 {
> + 	compatible = "qcom,i2c-qup";
> + 	reg = <0xf9924000 0x1000>;
> + 	interrupts = <0 96 0>;
> +
> + 	clocks = <&gcc_blsp1_qup2_i2c_apps_clk>, <&gcc_blsp1_ahb_clk>;

In the light of the latest patches from Stephen, this could be 

+ 	clocks = <&gcc GCC_BLSP1_QUP2_I2C_APPS_CLK>, <&gcc GCC_BLSP1_AHB_CLK>;


Regards,
Ivan