[PATCH v3] sky2: allow mac to come from dt

[Tim Harvey <tharvey@gateworks.com>]

The driver reads the mac address from the device registers which would
need to have been programmed by the bootloader.  This patch adds
the ability to pull the mac from devicetree via the pci device dt node.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Cc: netdev@vger.kernel.org
Cc: devicetree@vger.kernel.org
Cc: Grant Likely <grant.likely@linaro.org>
Cc: Rob Herring <robh+dt@kernel.org>

Changes since v2:
 - eliminated use of stack tmpaddr per feedback

Changes since v1:
 - simplified based on feedback
 - fixed formatting
---
 drivers/net/ethernet/marvell/sky2.c | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c
index 55a37ae..2434611 100644
--- a/drivers/net/ethernet/marvell/sky2.c
+++ b/drivers/net/ethernet/marvell/sky2.c
@@ -44,6 +44,8 @@
 #include <linux/prefetch.h>
 #include <linux/debugfs.h>
 #include <linux/mii.h>
+#include <linux/of_device.h>
+#include <linux/of_net.h>
 
 #include <asm/irq.h>
 
@@ -4748,6 +4750,7 @@ static struct net_device *sky2_init_netdev(struct sky2_hw *hw, unsigned port,
 {
 	struct sky2_port *sky2;
 	struct net_device *dev = alloc_etherdev(sizeof(*sky2));
+	const void *iap;
 
 	if (!dev)
 		return NULL;
@@ -4805,8 +4808,16 @@ static struct net_device *sky2_init_netdev(struct sky2_hw *hw, unsigned port,
 
 	dev->features |= dev->hw_features;
 
-	/* read the mac address */
-	memcpy_fromio(dev->dev_addr, hw->regs + B2_MAC_1 + port * 8, ETH_ALEN);
+	/* try to get mac address in the following order:
+	 * 1) from device tree data
+	 * 2) from internal registers set by bootloader
+	 */
+	iap = of_get_mac_address(hw->pdev->dev.of_node);
+	if (iap)
+		memcpy(dev->dev_addr, iap, ETH_ALEN);
+	else
+		memcpy_fromio(dev->dev_addr, hw->regs + B2_MAC_1 + port * 8,
+			      ETH_ALEN);
 
 	return dev;
 }
-- 
1.8.3.2