From: Kishon Vijay Abraham I <kishon@ti.com>
To: devicetree@vger.kernel.org, linux-doc@vger.kernel.org,
linux-kernel@vger.kernel.org,
linux-arm-kernel@lists.infradead.org, linux-omap@vger.kernel.org,
linux-pci@vger.kernel.org, bhelgaas@google.com,
mohit.kumar@st.com, jg1.han@samsung.com
Cc: robh+dt@kernel.org, pawel.moll@arm.com, mark.rutland@arm.com,
ijc+devicetree@hellion.org.uk, galak@codeaurora.org,
rob@landley.net, linux@arm.linux.org.uk, tony@atomide.com,
rnayak@ti.com, paul@pwsan.com, kishon@ti.com
Subject: [RFC PATCH 00/12] PCIe support for DRA7xx
Date: Wed, 26 Mar 2014 19:27:40 +0530 [thread overview]
Message-ID: <1395842272-15267-1-git-send-email-kishon@ti.com> (raw)
This patch series adds support for PCIe in DRA7xx including drivers and dt
data. PCIe in DRA7xx uses desingware IP and hence this re-uses the
pcie desingware driver (pcie-designware.c) by Jingoo.
This patch series depends on a few patches that is already in -next.
Tested broadcom PCIe card and XIO2000 bridge along with DGE530T ethernet
card.
Keerthy (2):
ARM: dts: DRA7: Add divider table to optfclk_pciephy_div clock
ARM: dts: DRA7: Change the parent of apll_pcie_in_clk_mux to
dpll_pcie_ref_m2ldo_ck
Kishon Vijay Abraham I (10):
phy: phy-omap-pipe3: Add support for PCIe PHY
pci: host: pcie-dra7xx: add support for pcie-dra7xx controller
pci: host: pcie-designware: Use *base-mask* for configuring the iATU
arm: dra7xx: Add hwmod data for pcie1 phy and pcie2 phy
arm: dra7xx: Add hwmod data for pcie1 and pcie2 subsystems
ARM: dts: dra7xx-clocks: Add missing 32khz clocks used for PHY
ARM: dts: dra7: Add dt data for PCIe PHY control module
ARM: dts: dra7: Add dt data for PCIe PHY
ARM: dts: dra7: Add dt data for PCIe controller
ARM: OMAP: Enable PCI for DRA7
.../devicetree/bindings/pci/designware-pcie.txt | 1 +
Documentation/devicetree/bindings/pci/ti-pci.txt | 35 ++
Documentation/devicetree/bindings/phy/ti-phy.txt | 8 +-
arch/arm/boot/dts/dra7.dtsi | 48 +++
arch/arm/boot/dts/dra7xx-clocks.dtsi | 11 +-
arch/arm/mach-omap2/Kconfig | 2 +
arch/arm/mach-omap2/cm2_7xx.h | 4 +
arch/arm/mach-omap2/omap_hwmod_7xx_data.c | 112 ++++++
arch/arm/mach-omap2/prm7xx.h | 4 +
drivers/pci/host/Kconfig | 10 +
drivers/pci/host/Makefile | 1 +
drivers/pci/host/pcie-designware.c | 39 +-
drivers/pci/host/pcie-designware.h | 1 +
drivers/pci/host/pcie-dra7xx.c | 411 ++++++++++++++++++++
drivers/phy/phy-ti-pipe3.c | 99 ++++-
15 files changed, 750 insertions(+), 36 deletions(-)
create mode 100644 Documentation/devicetree/bindings/pci/ti-pci.txt
create mode 100644 drivers/pci/host/pcie-dra7xx.c
--
1.7.9.5
next reply other threads:[~2014-03-26 13:57 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-03-26 13:57 Kishon Vijay Abraham I [this message]
2014-03-26 13:57 ` [RFC PATCH 01/12] phy: phy-omap-pipe3: Add support for PCIe PHY Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 02/12] pci: host: pcie-dra7xx: add support for pcie-dra7xx controller Kishon Vijay Abraham I
2014-03-26 14:45 ` Rob Herring
2014-03-26 15:19 ` Kishon Vijay Abraham I
2014-03-27 3:43 ` Jingoo Han
2014-03-27 5:26 ` Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 03/12] pci: host: pcie-designware: Use *base-mask* for configuring the iATU Kishon Vijay Abraham I
2014-03-27 11:45 ` Jingoo Han
2014-03-27 11:53 ` Mohit KUMAR DCG
[not found] ` <000001cf49b1$fcd8a810$f689f830$%han-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2014-03-27 17:32 ` Marek Vasut
2014-03-26 13:57 ` [RFC PATCH 04/12] ARM: dts: DRA7: Add divider table to optfclk_pciephy_div clock Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 05/12] ARM: dts: DRA7: Change the parent of apll_pcie_in_clk_mux to dpll_pcie_ref_m2ldo_ck Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 06/12] arm: dra7xx: Add hwmod data for pcie1 phy and pcie2 phy Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 07/12] arm: dra7xx: Add hwmod data for pcie1 and pcie2 subsystems Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 08/12] ARM: dts: dra7xx-clocks: Add missing 32khz clocks used for PHY Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 09/12] ARM: dts: dra7: Add dt data for PCIe PHY control module Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 10/12] ARM: dts: dra7: Add dt data for PCIe PHY Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 11/12] ARM: dts: dra7: Add dt data for PCIe controller Kishon Vijay Abraham I
2014-03-26 13:57 ` [RFC PATCH 12/12] ARM: OMAP: Enable PCI for DRA7 Kishon Vijay Abraham I
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1395842272-15267-1-git-send-email-kishon@ti.com \
--to=kishon@ti.com \
--cc=bhelgaas@google.com \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=ijc+devicetree@hellion.org.uk \
--cc=jg1.han@samsung.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux-pci@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=mark.rutland@arm.com \
--cc=mohit.kumar@st.com \
--cc=paul@pwsan.com \
--cc=pawel.moll@arm.com \
--cc=rnayak@ti.com \
--cc=rob@landley.net \
--cc=robh+dt@kernel.org \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).