From: Tony Lindgren <tony@atomide.com>
To: lee.jones@linaro.org
Cc: linux-arm-kernel@lists.infradead.org, linux-omap@vger.kernel.org,
devicetree@vger.kernel.org
Subject: [PATCH 7/7] ARM: dts: Enable twl4030 off-idle configuration for selected omaps
Date: Tue, 13 May 2014 18:34:10 -0700 [thread overview]
Message-ID: <1400031250-29542-8-git-send-email-tony@atomide.com> (raw)
In-Reply-To: <1400031250-29542-1-git-send-email-tony@atomide.com>
N900 now seems to shut down the external oscillator when hitting
off-idle.
And Beagle XM seems to have OSC_EN pin connected to allow shutting
down the oscillator looking at the schematics. The oscillator
output is cut off in off-idle and you can monitor it from R56 on
the bottom side of the board near the power jack. Note that for
beagle we need to also enable the UART wake-up event, the others
have that enabled in earlier patches.
OMAP37XX EVM (TMDSEVM3730) does not seem to have twl4030 clken
pin connected, so there is no point trying to enable shutting
down of the oscillator on it for the extra latency it adds.
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
arch/arm/boot/dts/omap3-beagle-xm.dts | 6 ++++++
arch/arm/boot/dts/omap3-evm-common.dtsi | 7 +++++++
arch/arm/boot/dts/omap3-n900.dts | 5 +++++
3 files changed, 18 insertions(+)
diff --git a/arch/arm/boot/dts/omap3-beagle-xm.dts b/arch/arm/boot/dts/omap3-beagle-xm.dts
index 447e714..b05814b 100644
--- a/arch/arm/boot/dts/omap3-beagle-xm.dts
+++ b/arch/arm/boot/dts/omap3-beagle-xm.dts
@@ -152,6 +152,11 @@
codec {
};
};
+
+ twl_power: power {
+ compatible = "ti,twl4030-power-beagleboard-xm", "ti,twl4030-power-idle-osc-off";
+ ti,use_poweroff;
+ };
};
};
@@ -211,6 +216,7 @@
};
&uart3 {
+ interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
pinctrl-names = "default";
pinctrl-0 = <&uart3_pins>;
};
diff --git a/arch/arm/boot/dts/omap3-evm-common.dtsi b/arch/arm/boot/dts/omap3-evm-common.dtsi
index 3007e79..7e44e29 100644
--- a/arch/arm/boot/dts/omap3-evm-common.dtsi
+++ b/arch/arm/boot/dts/omap3-evm-common.dtsi
@@ -45,6 +45,13 @@
#include "twl4030.dtsi"
#include "twl4030_omap3.dtsi"
+&twl {
+ twl_power: power {
+ compatible = "ti,twl4030-power-omap3-evm", "ti,twl4030-power-idle";
+ ti,use_poweroff;
+ };
+};
+
&i2c2 {
clock-frequency = <400000>;
};
diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts
index 869bdd9..09ae615 100644
--- a/arch/arm/boot/dts/omap3-n900.dts
+++ b/arch/arm/boot/dts/omap3-n900.dts
@@ -277,6 +277,11 @@
compatible = "ti,twl4030-audio";
ti,enable-vibra = <1>;
};
+
+ twl_power: power {
+ compatible = "ti,twl4030-power-n900", "ti,twl4030-power-idle-osc-off";
+ ti,use_poweroff;
+ };
};
&twl_gpio {
--
1.8.1.1
next prev parent reply other threads:[~2014-05-14 1:34 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-05-14 1:34 [PATCH v2 0/7] mfd: twl4030-power: Enable off-idle configuration when booted with device tree Tony Lindgren
2014-05-14 1:34 ` [PATCH 1/7] mfd: twl4030-power: Fix hang on reboot if sleep configuration was loaded earlier Tony Lindgren
2014-05-20 15:01 ` Lee Jones
2014-05-20 15:07 ` Tony Lindgren
2014-05-20 17:37 ` Lee Jones
2014-05-20 17:48 ` Tony Lindgren
2014-05-20 17:55 ` Lee Jones
2014-05-14 1:34 ` [PATCH 2/7] mfd: twl4030-power: Fix some defines for SW_EVENTS Tony Lindgren
2014-05-20 15:03 ` Lee Jones
2014-05-21 2:33 ` Tony Lindgren
2014-05-14 1:34 ` [PATCH 3/7] mfd: twl4030-power: Add generic reset configuration Tony Lindgren
2014-05-20 15:12 ` Lee Jones
2014-05-21 2:39 ` Tony Lindgren
2014-05-14 1:34 ` [PATCH 4/7] mfd: twl4030-power: Add recommended idle configuration Tony Lindgren
[not found] ` <1400031250-29542-5-git-send-email-tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org>
2014-05-20 15:14 ` Lee Jones
2014-05-21 2:44 ` Tony Lindgren
2014-05-14 1:34 ` [PATCH 5/7] mfd: twl4030-power: Add support for board specific configuration Tony Lindgren
2014-05-20 15:17 ` Lee Jones
2014-05-21 2:45 ` Tony Lindgren
2014-05-21 9:18 ` Lee Jones
2014-05-21 14:41 ` Tony Lindgren
2014-05-21 15:06 ` Lee Jones
2014-05-14 1:34 ` [PATCH 6/7] mfd: twl4030power: Add a configuration to turn off oscillator during off-idle Tony Lindgren
2014-05-14 1:34 ` Tony Lindgren [this message]
2014-05-21 9:23 ` [PATCH v2 0/7] mfd: twl4030-power: Enable off-idle configuration when booted with device tree Lee Jones
2014-05-21 14:49 ` Tony Lindgren
[not found] ` <1400031250-29542-1-git-send-email-tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org>
2014-05-27 16:52 ` Lee Jones
2014-05-27 17:13 ` Tony Lindgren
2014-05-28 7:03 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1400031250-29542-8-git-send-email-tony@atomide.com \
--to=tony@atomide.com \
--cc=devicetree@vger.kernel.org \
--cc=lee.jones@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).