From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peter Griffin Subject: [PATCH v2 2/4] reset: sti: Document sti-picophyreset controllers bindings. Date: Wed, 2 Jul 2014 15:08:47 +0100 Message-ID: <1404310129-14667-3-git-send-email-peter.griffin@linaro.org> References: <1404310129-14667-1-git-send-email-peter.griffin@linaro.org> Return-path: In-Reply-To: <1404310129-14667-1-git-send-email-peter.griffin-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org> Sender: devicetree-owner-u79uwXL29TY76Z2rM5mHXA@public.gmane.org To: linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org, linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org, p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org, srinivas.kandagatla-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org, maxime.coquelin-qxv4g6HH51o@public.gmane.org, patrice.chotard-qxv4g6HH51o@public.gmane.org Cc: peter.griffin-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org, lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org, devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org List-Id: devicetree@vger.kernel.org Add DT bindings documentation for sti-picophyreset controller. Signed-off-by: Peter Griffin --- .../bindings/reset/st,sti-picophyreset.txt | 42 ++++++++++++++++++++++ 1 file changed, 42 insertions(+) create mode 100644 Documentation/devicetree/bindings/reset/st,sti-picophyreset.txt diff --git a/Documentation/devicetree/bindings/reset/st,sti-picophyreset.txt b/Documentation/devicetree/bindings/reset/st,sti-picophyreset.txt new file mode 100644 index 0000000..54ae9f7 --- /dev/null +++ b/Documentation/devicetree/bindings/reset/st,sti-picophyreset.txt @@ -0,0 +1,42 @@ +STMicroelectronics STi family Sysconfig Picophy SoftReset Controller +============================================================================= + +This binding describes a reset controller device that is used to enable and +disable on-chip PicoPHY USB2 phy(s) using "softreset" control bits found in +the STi family SoC system configuration registers. + +The actual action taken when softreset is asserted is hardware dependent. +However, when asserted it may not be possible to access the hardware's +registers and after an assert/deassert sequence the hardware's previous state +may no longer be valid. + +Please refer to Documentation/devicetree/bindings/reset/reset.txt +for common reset controller binding usage. + +Required properties: +- compatible: Should be "st,stih407-picophyreset" +- #reset-cells: 1, see below + +Example: + + picophyreset: picophyreset-controller { + compatible = "st,stih407-picophyreset"; + #reset-cells = <1>; + }; + +Specifying picophyreset control of devices +======================================= + +Device nodes should specify the reset channel required in their "resets" +property, containing a phandle to the picophyreset device node and an +index specifying which channel to use, as described in +Documentation/devicetree/bindings/reset/reset.txt. + +Example: + + usb2_picophy0: usbpicophy@0 { + resets = <&picophyreset STIH407_PICOPHY0_RESET>; + }; + +Macro definitions for the supported reset channels can be found in: +include/dt-bindings/reset-controller/stih407-resets.h -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org More majordomo info at http://vger.kernel.org/majordomo-info.html