[PATCH v4 0/3] Add ST dwc3 glue layer driver

[Peter Griffin <peter.griffin@linaro.org>]

This series adds support for the ST glue logic which wraps the DWC3 controller
on STiH407 SoC family chipsets.

Changes since v3
 - Various formating nits

Changes since v2
 - Use dr_mode for host/device static configuration
 - Manage shared reset signal to usbss to avoid hang if probing before usb3 phy
 - Remove DT checks and make driver depend on OF
 - Change some #define to use BIT macro
 - Make some comments clearer
 - Use kerneldoc for struct documentation
 - Remove udelay
 - Let DT create platform_devices, and remove legacy alloc
 - Change some logging levels to dev_dbg
 - Various whitespace and formatting cleanup
 - Use SIMPLE_DEV_PM_OPS()
 - Add const to of_device struct
 - Reorder header files alphabetically
 - Use devm_ioremap_resource instead of devm_request_and_ioremap
 - Remove of_match_ptr()

Changes since v1
 - Fix Kconfig mistake

Peter Griffin (3):
  usb: dwc3: add ST dwc3 glue layer to manage dwc3 HC
  usb: dwc3: dwc3-st: Add st-dwc3 devicetree bindings documentation
  MAINTAINERS: Add dwc3-st.c file to ARCH/STI architecture

 Documentation/devicetree/bindings/usb/dwc3-st.txt |  69 +++++
 MAINTAINERS                                       |   1 +
 drivers/usb/dwc3/Kconfig                          |   9 +
 drivers/usb/dwc3/Makefile                         |   1 +
 drivers/usb/dwc3/dwc3-st.c                        | 336 ++++++++++++++++++++++
 5 files changed, 416 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/dwc3-st.txt
 create mode 100644 drivers/usb/dwc3/dwc3-st.c

-- 
1.9.1