From mboxrd@z Thu Jan 1 00:00:00 1970 From: Sebastian Reichel Subject: [PATCHv2 3/4] Documentation: DT: lis302: update wakeup binding Date: Sat, 21 Mar 2015 21:19:04 +0100 Message-ID: <1426969145-4478-4-git-send-email-sre@kernel.org> References: <1426969145-4478-1-git-send-email-sre@kernel.org> Return-path: In-Reply-To: <1426969145-4478-1-git-send-email-sre@kernel.org> Sender: linux-omap-owner@vger.kernel.org To: Sebastian Reichel , Eric Piel , =?UTF-8?q?Beno=C3=AEt=20Cousson?= , Tony Lindgren Cc: linux-omap@vger.kernel.org, Rob Herring , Pawel Moll , Mark Rutland , Ian Campbell , Kumar Gala , devicetree@vger.kernel.org, Sebastian Reichel List-Id: devicetree@vger.kernel.org From: Sebastian Reichel This updated the documentation of the DT binding to describe the added wakeup threshold and second wakeup engine. It also adds a note, that the axis values may be negative. Signed-off-by: Sebastian Reichel --- Documentation/devicetree/bindings/misc/lis302.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/misc/lis302.txt b/Documentation/devicetree/bindings/misc/lis302.txt index 6def86f..2a19bff 100644 --- a/Documentation/devicetree/bindings/misc/lis302.txt +++ b/Documentation/devicetree/bindings/misc/lis302.txt @@ -46,11 +46,18 @@ Optional properties for all bus drivers: interrupt 2 - st,wakeup-{x,y,z}-{lo,hi}: set wakeup condition on x/y/z axis for upper/lower limit + - st,wakeup-threshold: set wakeup threshold + - st,wakeup2-{x,y,z}-{lo,hi}: set wakeup condition on x/y/z axis for + upper/lower limit for second wakeup + engine. + - st,wakeup2-threshold: set wakeup threshold for second wakeup + engine. - st,highpass-cutoff-hz=: 1, 2, 4 or 8 for 1Hz, 2Hz, 4Hz or 8Hz of highpass cut-off frequency - st,hipass{1,2}-disable: disable highpass 1/2. - st,default-rate=: set the default rate - - st,axis-{x,y,z}=: set the axis to map to the three coordinates + - st,axis-{x,y,z}=: set the axis to map to the three coordinates. + Negative values can be used for inverted axis. - st,{min,max}-limit-{x,y,z} set the min/max limits for x/y/z axis (used by self-test) -- 2.1.4