[PATCH 03/17] phy: ti-pipe3: use *syscon* framework to set PCS value of the PHY

[Kishon Vijay Abraham I <kishon@ti.com>]

Deprecate using phy-omap-control driver to set PCS value of the PHY
and start using *syscon* framework to do the same.

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
---
 Documentation/devicetree/bindings/phy/ti-phy.txt |    2 ++
 drivers/phy/phy-ti-pipe3.c                       |   32 +++++++++++++++++++++-
 2 files changed, 33 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/phy/ti-phy.txt b/Documentation/devicetree/bindings/phy/ti-phy.txt
index d3ad3bf..52c7a92 100644
--- a/Documentation/devicetree/bindings/phy/ti-phy.txt
+++ b/Documentation/devicetree/bindings/phy/ti-phy.txt
@@ -83,6 +83,8 @@ Optional properties:
  - syscon-pllreset: Handle to system control region that contains the
    CTRL_CORE_SMA_SW_0 register and register offset to the CTRL_CORE_SMA_SW_0
    register that contains the SATA_PLL_SOFT_RESET bit. Only valid for sata_phy.
+ - syscon-pcs : phandle/offset pair. Phandle to the system control module and the
+   register offset to write the PCS delay value.
 
 Deprecated properties:
  - ctrl-module : phandle of the control module used by PHY driver to power on
diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
index 78bac00..e2f9ad7 100644
--- a/drivers/phy/phy-ti-pipe3.c
+++ b/drivers/phy/phy-ti-pipe3.c
@@ -65,6 +65,9 @@
 #define PIPE3_PHY_TX_RX_POWERON		0x3
 #define PIPE3_PHY_TX_RX_POWEROFF	0x0
 
+#define PCIE_PCS_MASK			0xFF0000
+#define PCIE_PCS_DELAY_COUNT_SHIFT	0x10
+
 /*
  * This is an Empirical value that works, need to confirm the actual
  * value required for the PIPE3PHY_PLL_CONFIGURATION2.PLL_IDLE status
@@ -96,9 +99,11 @@ struct ti_pipe3 {
 	struct clk		*div_clk;
 	struct pipe3_dpll_map	*dpll_map;
 	struct regmap		*phy_power_syscon; /* ctrl. reg. acces */
+	struct regmap		*pcs_syscon; /* ctrl. reg. acces */
 	struct regmap		*dpll_reset_syscon; /* ctrl. reg. acces */
 	unsigned int		dpll_reset_reg; /* reg. index within syscon */
 	unsigned int		power_reg; /* power reg. index within syscon */
+	unsigned int		pcie_pcs_reg; /* pcs reg. index in syscon */
 	bool			sata_refclk_enabled;
 };
 
@@ -271,7 +276,16 @@ static int ti_pipe3_init(struct phy *x)
 	 * 18-1804.
 	 */
 	if (of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie")) {
-		omap_control_pcie_pcs(phy->control_dev, 0x96);
+		if (phy->pcs_syscon) {
+			val = 0x96 << OMAP_CTRL_PCIE_PCS_DELAY_COUNT_SHIFT;
+			ret = regmap_update_bits(phy->pcs_syscon,
+						 phy->pcie_pcs_reg,
+						 PCIE_PCS_MASK, val);
+			if (ret < 0)
+				return ret;
+		} else {
+			omap_control_pcie_pcs(phy->control_dev, 0x96);
+		}
 		return 0;
 	}
 
@@ -455,6 +469,22 @@ static int ti_pipe3_probe(struct platform_device *pdev)
 			dev_err(&pdev->dev, "unable to get div-clk\n");
 			return PTR_ERR(phy->div_clk);
 		}
+
+		phy->pcs_syscon = syscon_regmap_lookup_by_phandle(node,
+								  "syscon-pcs");
+		if (IS_ERR(phy->pcs_syscon)) {
+			dev_dbg(&pdev->dev,
+				 "can't get syscon-pcs, using omap control\n");
+			phy->pcs_syscon = NULL;
+		} else {
+			if (of_property_read_u32_index(node,
+						       "syscon-pcs", 1,
+						       &phy->pcie_pcs_reg)) {
+				dev_err(&pdev->dev,
+					"couldn't get pcie pcs reg. offset\n");
+				return -EINVAL;
+			}
+		}
 	} else {
 		phy->div_clk = ERR_PTR(-ENODEV);
 	}
-- 
1.7.9.5