From mboxrd@z Thu Jan 1 00:00:00 1970 From: Lee Jones Subject: [PATCH 1/3] regulator: pwm-regulator: Ensure headings aren't confused with properties Date: Thu, 9 Jul 2015 16:35:26 +0100 Message-ID: <1436456128-18278-1-git-send-email-lee.jones@linaro.org> Return-path: Sender: linux-kernel-owner@vger.kernel.org To: linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org Cc: kernel@stlinux.com, broonie@kernel.org, lgirdwood@gmail.com, devicetree@vger.kernel.org, Lee Jones List-Id: devicetree@vger.kernel.org We're using capitalisation and removing the '-' to mitigate confusion. Signed-off-by: Lee Jones --- Documentation/devicetree/bindings/regulator/pwm-regulator.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/regulator/pwm-regulator.txt b/Documentation/devicetree/bindings/regulator/pwm-regulator.txt index 892b366..23b4772 100644 --- a/Documentation/devicetree/bindings/regulator/pwm-regulator.txt +++ b/Documentation/devicetree/bindings/regulator/pwm-regulator.txt @@ -3,7 +3,7 @@ Bindings for the Generic PWM Regulator Currently supports 2 modes of operation: -voltage-table: When in this mode, a voltage table (See below) of +Voltage Table: When in this mode, a voltage table (See below) of predefined voltage <=> duty-cycle values must be provided via DT. Limitations are that the regulator can only operate at the voltages supplied in the table. @@ -13,7 +13,7 @@ voltage-table: When in this mode, a voltage table (See below) of the user if the assumptions made in continuous-voltage mode do not reign true. -continuous-voltage: This mode uses the regulator's maximum and minimum +Continuous Voltage: This mode uses the regulator's maximum and minimum supplied voltages specified in the regulator-{min,max}-microvolt properties to calculate appropriate duty-cycle values. This allows for a much -- 1.9.1