From: Philipp Zabel <p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
To: Yingjoe Chen <yingjoe.chen-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
Cc: dri-devel-PD4FTy7X32lNgt0PjOBp9y5qC8QIuHrW@public.gmane.org,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
Paul Bolle <pebolle-IWqWACnzNjzz+pZb47iToQ@public.gmane.org>,
YT Shen <yt.shen-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Jitao Shi <jitao.shi-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Jie Qiu <jie.qiu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Pawel Moll <pawel.moll-5wv7dgnIgG8@public.gmane.org>,
Ian Campbell
<ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org>,
Cawa Cheng <cawa.cheng-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Daniel Stone <daniel-rLtY4a/8tF1rovVCs/uTlw@public.gmane.org>,
Tomasz Figa <tfiga-F7+t8E8rja9g9hUCZPvPmw@public.gmane.org>,
CK Hu <ck.hu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>,
Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
linux-mediatek-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
Daniel Vetter <daniel-/w4YWyX8dFk@public.gmane.org>,
Kumar Gala <galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>,
Matthias Brugger
<matthias.bgg-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
Dave Airlie <airlied-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
kernel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org
Subject: Re: [PATCH v7 06/14] drm/mediatek: Add HDMI support
Date: Mon, 04 Jan 2016 20:23:28 +0100 [thread overview]
Message-ID: <1451935408.3884.48.camel@pengutronix.de> (raw)
In-Reply-To: <1451378973.15546.3.camel@mtksdaap41>
Am Dienstag, den 29.12.2015, 16:49 +0800 schrieb Yingjoe Chen:
> On Mon, 2015-11-30 at 22:07 +0100, Philipp Zabel wrote:
> > From: Jie Qiu <jie.qiu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
> >
> > This patch adds drivers for the HDMI bridge connected to the DPI0
> > display subsystem function block, for the HDMI DDC block, and for
> > the HDMI PHY to support HDMI output.
> >
> > Signed-off-by: Jie Qiu <jie.qiu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org>
> > Signed-off-by: Philipp Zabel <p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> > ---
> <...>
> > +static int mtk_hdmi_setup_avi_infoframe(struct mtk_hdmi *hdmi,
> > + struct drm_display_mode *mode)
> > +{
> > + struct hdmi_avi_infoframe frame;
> > + u8 buffer[17];
> > + ssize_t err;
> > +
> > + err = drm_hdmi_avi_infoframe_from_display_mode(&frame, mode);
> > + if (err < 0) {
> > + dev_err(hdmi->dev,
> > + "Failed to get AVI infoframe from mode: %ld\n", err);
>
> Please use %zd instead for ssize_t, otherwise you'll see warning message
> when compile this on 32bits platform.
>
> Joe.C
Ok, thanks.
regards
Philipp
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2016-01-04 19:23 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-30 21:07 [PATCH v7 00/14] MT8173 DRM support Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 01/14] dt-bindings: drm/mediatek: Add Mediatek display subsystem dts binding Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 02/14] drm/mediatek: Add DRM Driver for Mediatek SoC MT8173 Philipp Zabel
[not found] ` <1448917676-25584-3-git-send-email-p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2015-12-11 17:10 ` Matthias Brugger
[not found] ` <566B0378.7050809-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2015-12-11 17:23 ` Philipp Zabel
2015-12-14 18:57 ` Daniel Kurtz
[not found] ` <CAGS+omCeJU77tkjf4YGPiH9SZDo7aA4Cpbgih8RvvtSJVEKrnQ-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2015-12-16 9:52 ` Philipp Zabel
2015-12-16 16:10 ` Daniel Kurtz
2015-11-30 21:07 ` [PATCH v7 03/14] drm/mediatek: Add DSI sub driver Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 04/14] drm/mediatek: Add DPI " Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 05/14] dt-bindings: drm/mediatek: Add Mediatek HDMI dts binding Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 06/14] drm/mediatek: Add HDMI support Philipp Zabel
[not found] ` <1448917676-25584-7-git-send-email-p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2015-12-29 8:49 ` Yingjoe Chen
2016-01-04 19:23 ` Philipp Zabel [this message]
2015-11-30 21:07 ` [PATCH v7 07/14] drm/mediatek: enable hdmi output control bit Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 08/14] arm64: dts: mt8173: Add display subsystem related nodes Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 09/14] arm64: dts: mt8173: Add HDMI " Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 10/14] clk: mediatek: make dpi0_sel and hdmi_sel not propagate rate changes Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 11/14] clk: mediatek: Add hdmi_ref HDMI PHY PLL reference clock output Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 12/14] dt-bindings: hdmi-connector: add DDC I2C bus phandle documentation Philipp Zabel
2015-11-30 21:07 ` [PATCH v7 13/14] drm/atomic-helper: Export drm_atomic_helper_wait_for_fences Philipp Zabel
[not found] ` <1448917676-25584-1-git-send-email-p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
2015-11-30 21:07 ` [PATCH v7 14/14] drm/mediatek: Add fence control, wait on GPU fence Philipp Zabel
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1451935408.3884.48.camel@pengutronix.de \
--to=p.zabel-bicnvbalz9megne8c9+irq@public.gmane.org \
--cc=airlied-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=cawa.cheng-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=ck.hu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=daniel-/w4YWyX8dFk@public.gmane.org \
--cc=daniel-rLtY4a/8tF1rovVCs/uTlw@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=dri-devel-PD4FTy7X32lNgt0PjOBp9y5qC8QIuHrW@public.gmane.org \
--cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
--cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
--cc=jie.qiu-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=jitao.shi-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=kernel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org \
--cc=linux-mediatek-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=matthias.bgg-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
--cc=pebolle-IWqWACnzNjzz+pZb47iToQ@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=tfiga-F7+t8E8rja9g9hUCZPvPmw@public.gmane.org \
--cc=yingjoe.chen-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
--cc=yt.shen-NuS5LvNUpcJWk0Htik3J/w@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).