From mboxrd@z Thu Jan 1 00:00:00 1970 From: Joachim Eastwood Subject: [PATCH v2 2/2] devicetree: document NXP LPC1850 PINT irq controller binding Date: Sat, 2 Apr 2016 18:35:24 +0200 Message-ID: <1459614924-32670-3-git-send-email-manabian@gmail.com> References: <1459614924-32670-1-git-send-email-manabian@gmail.com> Return-path: In-Reply-To: <1459614924-32670-1-git-send-email-manabian@gmail.com> Sender: linux-kernel-owner@vger.kernel.org To: marc.zyngier@arm.com, jason@lakedaemon.net, tglx@linutronix.de, robh+dt@kernel.org Cc: Joachim Eastwood , devicetree@vger.kernel.org, linux-kernel@vger.kernel.org List-Id: devicetree@vger.kernel.org Add binding documentation for NXP LPC1850 GPIO Pin Interrupt (PINT) controller. Signed-off-by: Joachim Eastwood --- .../interrupt-controller/nxp,lpc1850-gpio-pint.txt | 26 ++++++++++++++++++++++ 1 file changed, 26 insertions(+) create mode 100644 Documentation/devicetree/bindings/interrupt-controller/nxp,lpc1850-gpio-pint.txt diff --git a/Documentation/devicetree/bindings/interrupt-controller/nxp,lpc1850-gpio-pint.txt b/Documentation/devicetree/bindings/interrupt-controller/nxp,lpc1850-gpio-pint.txt new file mode 100644 index 0000000..0d59d31 --- /dev/null +++ b/Documentation/devicetree/bindings/interrupt-controller/nxp,lpc1850-gpio-pint.txt @@ -0,0 +1,26 @@ +NXP LPC18xx/43xx GPIO Pin Interrupt (PINT) controller + +Required properties: + +- compatible : should be "nxp,lpc1850-gpio-pint". +- reg : Specifies base physical address and size of the registers. +- interrupt-controller : Identifies the node as an interrupt controller +- #interrupt-cells : Specifies the number of cells needed to encode an + interrupt source. The value shall be 2. +- interrupts : Must contain the interrupt numbers from the parent controller. + This defines the mapping between the controllers where the first + interrupt is mapped to pint hwirq 0 and so on. Which interrupts + that are connected to where and the number of is device specific. + For lpc1850 the mapping is 32 33 34 35 36 37 38 39 (8 in total). +- clocks: Must contain a reference to the functional clock. + +Example: + +pint: interrupt-controller@40087000 { + compatible = "nxp,lpc1850-gpio-pint"; + reg = <0x40087000 0x1000>; + interrupt-controller; + #interrupt-cells = <2>; + interrupts = <32 33 34 35 36 37 38 39>; + clocks = <&ccu1 CLK_CPU_GPIO>; +}; -- 2.8.0