[PATCH v2 2/2] sdhci-of-arasan: Set controller to test mode when Card Detection is broken.

[Zach Brown <zach.brown-acOepvfBmUk@public.gmane.org>]

The sdhci controller on xilinx zynq devices will not function unless
the CD bit is provided. http://www.xilinx.com/support/answers/61064.html
In cases where it is impossible to provide the CD bit in hardware,
setting the controller to test mode and then setting inserted to true
will get the controller to function without the CD bit.

When the device has the property broken-cd the driver changes the
controller to test mode and sets test inserted to true to make the
controller function.

Signed-off-by: Zach Brown <zach.brown-acOepvfBmUk@public.gmane.org>
---
 drivers/mmc/host/sdhci-of-arasan.c | 17 ++++++++++++++++-
 drivers/mmc/host/sdhci.h           |  2 ++
 2 files changed, 18 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
index e0f193f..3798a3b 100644
--- a/drivers/mmc/host/sdhci-of-arasan.c
+++ b/drivers/mmc/host/sdhci-of-arasan.c
@@ -26,6 +26,7 @@
 #include <linux/phy/phy.h>
 #include <linux/regmap.h>
 #include "sdhci-pltfm.h"
+#include <linux/of.h>
 
 #define SDHCI_ARASAN_CLK_CTRL_OFFSET	0x2c
 #define SDHCI_ARASAN_VENDOR_REGISTER	0x78
@@ -203,12 +204,26 @@ static void sdhci_arasan_hs400_enhanced_strobe(struct mmc_host *mmc,
 	writel(vendor, host->ioaddr + SDHCI_ARASAN_VENDOR_REGISTER);
 }
 
+void sdhci_arasan_reset(struct sdhci_host *host, u8 mask)
+{
+	u8 ctrl;
+
+	sdhci_reset(host, mask);
+
+	if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) {
+		ctrl = sdhci_readb(host, SDHCI_HOST_CONTROL);
+		ctrl |= SDHCI_CTRL_CDTEST_INS |
+			SDHCI_CTRL_CDTEST_EN;
+		sdhci_writeb(host, ctrl, SDHCI_HOST_CONTROL);
+	}
+}
+
 static struct sdhci_ops sdhci_arasan_ops = {
 	.set_clock = sdhci_arasan_set_clock,
 	.get_max_clock = sdhci_pltfm_clk_get_max_clock,
 	.get_timeout_clock = sdhci_arasan_get_timeout_clock,
 	.set_bus_width = sdhci_set_bus_width,
-	.reset = sdhci_reset,
+	.reset = sdhci_arasan_reset,
 	.set_uhs_signaling = sdhci_set_uhs_signaling,
 };
 
diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h
index 0411c9f..8d92d6e9 100644
--- a/drivers/mmc/host/sdhci.h
+++ b/drivers/mmc/host/sdhci.h
@@ -84,6 +84,8 @@
 #define   SDHCI_CTRL_ADMA32	0x10
 #define   SDHCI_CTRL_ADMA64	0x18
 #define   SDHCI_CTRL_8BITBUS	0x20
+#define  SDHCI_CTRL_CDTEST_INS   0x40
+#define  SDHCI_CTRL_CDTEST_EN     0x80
 
 #define SDHCI_POWER_CONTROL	0x29
 #define  SDHCI_POWER_ON		0x01
-- 
2.7.4

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html