From: Varadarajan Narayanan <varada-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
To: broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
mark.rutland-5wv7dgnIgG8@public.gmane.org,
andy.gross-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org,
david.brown-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org,
linux-spi-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-arm-msm-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-soc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Cc: Varadarajan Narayanan <varada-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
Subject: [PATCH v4 00/14] spi: qup: Fixes and add support for >64k transfers
Date: Tue, 27 Jun 2017 15:15:17 +0530 [thread overview]
Message-ID: <1498556731-13087-1-git-send-email-varada@codeaurora.org> (raw)
v4:
Discard patch #15, 'spi: qup: support for qup v1 dma'.
This depends on ADM driver, which is not upstreamed yet.
v3:
Fix git bisect-ability issues in
spi: qup: Add completion structures for DMA
spi: qup: Add completion timeout
spi: qup: Place the QUP in run mode before DMA
spi: qup: Fix transaction done signaling
v2:
Incorporate feedback from Andy Gross, Sricharan, Stanimir Varbanov
Modified the QUP-v1 dma completion sequence to QUP-v2 as per feedback.
Removed code that used controller->xfer to identify extra interrupts,
since with the fixes done to handle i/o completion we don't see
extra interrupts.
v1:
This series fixes some existing issues in the code for both
interrupt and dma mode. Patches 1 - 11 are the fixes.
Random failures/timeout are observed without these fixes.
Also, the current driver does not support block transfers > 64K
and the driver quietly fails. Patches 12 - 18 add support for this
in both interrupt and dma mode.
The entire series has been tested on ipq4019 with
SPI-NOR flash for block sizes > 64k.
Varadarajan Narayanan (14):
spi: qup: Enable chip select support
spi: qup: Setup DMA mode correctly
spi: qup: Add completion structures for DMA
spi: qup: Add completion timeout
spi: qup: Place the QUP in run mode before DMA
spi: qup: Fix error handling in spi_qup_prep_sg
spi: qup: Fix transaction done signaling
spi: qup: Do block sized read/write in block mode
spi: qup: refactor spi_qup_io_config into two functions
spi: qup: call io_config in mode specific function
spi: qup: allow block mode to generate multiple transactions
spi: qup: refactor spi_qup_prep_sg
spi: qup: allow multiple DMA transactions per spi xfer
spi: qup: Ensure done detection
drivers/spi/spi-qup.c | 597 ++++++++++++++++++++++++++++++++++----------------
1 file changed, 408 insertions(+), 189 deletions(-)
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next reply other threads:[~2017-06-27 9:45 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-06-27 9:45 Varadarajan Narayanan [this message]
2017-06-27 9:45 ` [PATCH v4 01/14] spi: qup: Enable chip select support Varadarajan Narayanan
2017-07-17 16:01 ` Mark Brown
[not found] ` <20170717160151.teozg2ni4mqxotbd-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
2017-07-20 5:30 ` Varadarajan Narayanan
[not found] ` <1498556731-13087-2-git-send-email-varada-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2017-07-20 7:03 ` Geert Uytterhoeven
[not found] ` <1498556731-13087-1-git-send-email-varada-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2017-06-27 9:45 ` [PATCH v4 02/14] spi: qup: Setup DMA mode correctly Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 03/14] spi: qup: Add completion structures for DMA Varadarajan Narayanan
2017-07-17 16:02 ` Mark Brown
2017-06-27 9:45 ` [PATCH v4 04/14] spi: qup: Add completion timeout Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 06/14] spi: qup: Fix error handling in spi_qup_prep_sg Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 05/14] spi: qup: Place the QUP in run mode before DMA Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 07/14] spi: qup: Fix transaction done signaling Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 08/14] spi: qup: Do block sized read/write in block mode Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 09/14] spi: qup: refactor spi_qup_io_config into two functions Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 10/14] spi: qup: call io_config in mode specific function Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 11/14] spi: qup: allow block mode to generate multiple transactions Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 12/14] spi: qup: refactor spi_qup_prep_sg Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 13/14] spi: qup: allow multiple DMA transactions per spi xfer Varadarajan Narayanan
2017-06-27 9:45 ` [PATCH v4 14/14] spi: qup: Ensure done detection Varadarajan Narayanan
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1498556731-13087-1-git-send-email-varada@codeaurora.org \
--to=varada-sgv2jx0feol9jmxxk+q4oq@public.gmane.org \
--cc=andy.gross-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
--cc=broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=david.brown-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-arm-msm-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-soc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-spi-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).