[PATCH v2 2/2] dt-bindings: edac: Aspeed AST2500

[Stefan Schaeckeler <schaecsn@gmx.net>]

From: Stefan M Schaeckeler <sschaeck@cisco.com>

Add support for EDAC on the Aspeed AST2500 SoC.

Signed-off-by: Stefan M Schaeckeler <sschaeck@cisco.com>
---
 .../bindings/edac/aspeed-sdram-edac.txt       | 25 +++++++++++++++++++
 1 file changed, 25 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt

diff --git a/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
new file mode 100644
index 000000000000..6a0f3d90d682
--- /dev/null
+++ b/Documentation/devicetree/bindings/edac/aspeed-sdram-edac.txt
@@ -0,0 +1,25 @@
+Aspeed AST2500 SoC EDAC node
+
+The Aspeed AST2500 SoC supports DDR3 and DDR4 memory with and without ECC (error
+correction check).
+
+The memory controller supports SECDED (single bit error correction, double bit
+error detection) and single bit error auto scrubbing by reserving 8 bits for
+every 64 bit word (effectively reducing available memory to 8/9).
+
+Note, the bootloader must configure ECC mode in the memory controller.
+
+
+Required properties:
+- compatible: should be "aspeed,ast2500-sdram-edac"
+- reg:        sdram controller register set should be <0x1e6e0000 0x174>
+- interrupts: should be AVIC interrupt #0
+
+
+Example:
+
+	edac: sdram@1e6e0000 {
+		compatible = "aspeed,ast2500-sdram-edac";
+		reg = <0x1e6e0000 0x174>;
+		interrupts = <0>;
+	};
-- 
2.19.1