[PATCH v3 0/2] Add macb support for SiFive FU540-C000

[Yash Shah <yash.shah@sifive.com>]

On FU540, the management IP block is tightly coupled with the Cadence
MACB IP block. It manages many of the boundary signals from the MACB IP
This patchset controls the tx_clk input signal to the MACB IP. It
switches between the local TX clock (125MHz) and PHY TX clocks. This
is necessary to toggle between 1Gb and 100/10Mb speeds.

Future patches may add support for monitoring or controlling other IP
boundary signals.

This patchset is mostly based on work done by
Wesley Terpstra <wesley@sifive.com>

This patchset is based on Linux v5.2-rc1 and tested on HiFive Unleashed
board with additional board related patches needed for testing can be
found at dev/yashs/ethernet_v3 branch of:
https://github.com/yashshah7/riscv-linux.git

Change History:
V3:
- Revert "MACB_SIFIVE_FU540" config changes in Kconfig and driver code.
  The driver does not depend on SiFive GPIO driver.

V2:
- Change compatible string from "cdns,fu540-macb" to "sifive,fu540-macb"
- Add "MACB_SIFIVE_FU540" in Kconfig to support SiFive FU540 in macb
  driver. This is needed because on FU540, the macb driver depends on
  SiFive GPIO driver.
- Avoid writing the result of a comparison to a register.
- Fix the issue of probe fail on reloading the module reported by:
  Andreas Schwab <schwab@suse.de>

Yash Shah (2):
  macb: bindings doc: add sifive fu540-c000 binding
  macb: Add support for SiFive FU540-C000

 Documentation/devicetree/bindings/net/macb.txt |   3 +
 drivers/net/ethernet/cadence/macb_main.c       | 123 +++++++++++++++++++++++++
 2 files changed, 126 insertions(+)

-- 
1.9.1