[PATCH v2 06/10] net: hisilicon: dt-bindings: Add an field of port-handle

[Jiangfeng Xiao <xiaojiangfeng@huawei.com>]

In general, group is the same as the port, but some
boards specify a special group for better load
balancing of each processing unit.

Signed-off-by: Jiangfeng Xiao <xiaojiangfeng@huawei.com>
---
 Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt b/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
index d1df8a0..464c0da 100644
--- a/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
+++ b/Documentation/devicetree/bindings/net/hisilicon-hip04-net.txt
@@ -10,6 +10,7 @@ Required properties:
 	phandle, specifies a reference to the syscon ppe node
 	port, port number connected to the controller
 	channel, recv channel start from channel * number (RX_DESC_NUM)
+	group, field in the pkg desc, in general, it is the same as the port.
 - phy-mode: see ethernet.txt [1].
 
 Optional properties:
@@ -66,7 +67,7 @@ Example:
 		reg = <0x28b0000 0x10000>;
 		interrupts = <0 413 4>;
 		phy-mode = "mii";
-		port-handle = <&ppe 31 0>;
+		port-handle = <&ppe 31 0 31>;
 	};
 
 	ge0: ethernet@2800000 {
@@ -74,7 +75,7 @@ Example:
 		reg = <0x2800000 0x10000>;
 		interrupts = <0 402 4>;
 		phy-mode = "sgmii";
-		port-handle = <&ppe 0 1>;
+		port-handle = <&ppe 0 1 0>;
 		phy-handle = <&phy0>;
 	};
 
@@ -83,6 +84,6 @@ Example:
 		reg = <0x2880000 0x10000>;
 		interrupts = <0 410 4>;
 		phy-mode = "sgmii";
-		port-handle = <&ppe 8 2>;
+		port-handle = <&ppe 8 2 8>;
 		phy-handle = <&phy1>;
 	};
-- 
1.8.5.6