[PATCH RFC v2 06/14] dt-bindings/interrupt-controller: pdc: add SPI config register

[Lina Iyer <ilina@codeaurora.org>]

In addition to configuring the PDC, additional registers that interface
the GIC have to be configured to match the GPIO type. The registers on
some QCOM SoCs are access restricted, while on other SoCs are not. They
SoCs with access restriction to these SPI registers need to be written
from the firmware using the SCM interface. Add a flag to indicate if the
register is to be written using SCM interface.

Cc: devicetree@vger.kernel.org
Signed-off-by: Lina Iyer <ilina@codeaurora.org>
---
 .../devicetree/bindings/interrupt-controller/qcom,pdc.txt   | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/interrupt-controller/qcom,pdc.txt b/Documentation/devicetree/bindings/interrupt-controller/qcom,pdc.txt
index 8e0797c..e329f8d 100644
--- a/Documentation/devicetree/bindings/interrupt-controller/qcom,pdc.txt
+++ b/Documentation/devicetree/bindings/interrupt-controller/qcom,pdc.txt
@@ -24,6 +24,9 @@ Properties:
 	Usage: required
 	Value type: <prop-encoded-array>
 	Definition: Specifies the base physical address for PDC hardware.
+		    Optionally, specify the PDC's GIC interface registers that
+		    need to be configured for wakeup capable GPIOs routed to
+		    the PDC.
 
 - interrupt-cells:
 	Usage: required
@@ -50,15 +53,23 @@ Properties:
 		    The second element is the GIC hwirq number for the PDC port.
 		    The third element is the number of interrupts in sequence.
 
+- qcom,scm-spi-cfg:
+	Usage: optional
+	Value type: <bool>
+	Definition: Specifies if the SPI configuration registers have to be
+		    written from the firmware. Sometimes the PDC interface
+		    register to the GIC can only be written from the firmware.
+
 Example:
 
 	pdc: interrupt-controller@b220000 {
 		compatible = "qcom,sdm845-pdc";
-		reg = <0xb220000 0x30000>;
+		reg = <0 0x0b220000 0 0x30000>, <0 0x179900f0 0 0x60>;
 		qcom,pdc-ranges = <0 512 94>, <94 641 15>, <115 662 7>;
 		#interrupt-cells = <2>;
 		interrupt-parent = <&intc>;
 		interrupt-controller;
+		qcom,scm-spi-cfg;
 	};
 
 DT binding of a device that wants to use the GIC SPI 514 as a wakeup
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project