[PATCH 4/4] ARM: dts: phycore-imx6: set buck regulator modes explicitly

[Christoph Fritz <chf.fritz@googlemail.com>]

This patch sets initial buck regulator modes explicitly to a state
this hardware needs.  So a wrong initial mode set by bootloader or
pmic itself does not interfere anymore.

Signed-off-by: Christoph Fritz <chf.fritz@googlemail.com>
---
 arch/arm/boot/dts/imx6qdl-phytec-phycore-som.dtsi | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-phytec-phycore-som.dtsi b/arch/arm/boot/dts/imx6qdl-phytec-phycore-som.dtsi
index 6486df3..e3f2181 100644
--- a/arch/arm/boot/dts/imx6qdl-phytec-phycore-som.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-phytec-phycore-som.dtsi
@@ -5,6 +5,7 @@
  */
 
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/regulator/dlg,da906x-regulator.h>
 
 / {
 	aliases {
@@ -109,6 +110,7 @@
 				regulator-name = "vdd_arm";
 				regulator-min-microvolt = <730000>;
 				regulator-max-microvolt = <1380000>;
+				regulator-initial-mode = <DA906X_BUCK_MODE_SYNC>;
 				regulator-always-on;
 			};
 
@@ -116,6 +118,7 @@
 				regulator-name = "vdd_soc";
 				regulator-min-microvolt = <730000>;
 				regulator-max-microvolt = <1380000>;
+				regulator-initial-mode = <DA906X_BUCK_MODE_SYNC>;
 				regulator-always-on;
 			};
 
@@ -123,6 +126,7 @@
 				regulator-name = "vdd_ddr3";
 				regulator-min-microvolt = <1500000>;
 				regulator-max-microvolt = <1500000>;
+				regulator-initial-mode = <DA906X_BUCK_MODE_SYNC>;
 				regulator-always-on;
 			};
 
@@ -130,6 +134,7 @@
 				regulator-name = "vdd_eth";
 				regulator-min-microvolt = <1200000>;
 				regulator-max-microvolt = <1200000>;
+				regulator-initial-mode = <DA906X_BUCK_MODE_SYNC>;
 				regulator-always-on;
 			};
 
-- 
2.1.4