Re: [PATCH v3] dt-bindings: gpio: add common consumer GPIO lines

[Rob Herring <robh@kernel.org>]

On Fri, 01 Apr 2022 09:27:14 +0200, Krzysztof Kozlowski wrote:
> Typical GPIO lines like enable, powerdown, reset or wakeup are not
> documented as common, which leads to new variations of these (e.g.
> pwdn-gpios).  Add a common schema which serves also as a documentation
> for preferred naming.
> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> 
> ---
> 
> Changes since v2:
> 1. Correct email.
> 
> Changes since v1:
> 1. Select-true, add maxItems and description for each entry (Rob).
> 2. Mention ACTIVE_LOW in bindings description (Linus).
> 3. Add allOf for pwrseq reset-gpios case.
> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> ---
>  .../bindings/gpio/gpio-consumer-common.yaml   | 64 +++++++++++++++++++
>  1 file changed, 64 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/regulator/richtek,rt4801-regulator.example.dt.yaml: rt4801@73: enable-gpios: [[4294967295, 2, 0], [4294967295, 3, 0]] is too long
	From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/patch/

This check can fail if there are any dependencies. The base for a patch
series is generally the most recent rc1.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit.