Re: [PATCH RFC v3 0/6] phy: mvebu-cp110-utmi: add support for armada-380 utmi phys

["Rob Herring (Arm)" <robh@kernel.org>]

On Sat, 20 Jul 2024 16:19:17 +0200, Josua Mayer wrote:
> Armada 380 has smilar USB-2.0 PHYs as CP-110 (Armada 8K).
> 
> Add support for Armada 380 to cp110 utmi phy driver, and enable it for
> armada-388-clearfog boards.
> 
> Additionally add a small bugfix for armada-388 clearfog:
> Enable Clearfog Base M.2 connector for cellular modems with USB-2.0/3.0
> interface.
> This is not separated out to avoid future merge conflicts.
> 
> Signed-off-by: Josua Mayer <josua@solid-run.com>
> ---
> Changes in v3:
> - updated bindings with additional comments, tested with dtbs_check:
>   used anyOf for the newly-added optional regs
> - added fix for clearfog base m.2 connector / enable third usb
> - dropped unnecessary syscon node using invalid compatible
>   (Reported-by: Krzysztof Kozlowski <krzk@kernel.org>)
> - Link to v2: https://lore.kernel.org/r/20240716-a38x-utmi-phy-v2-0-dae3a9c6ca3e@solid-run.com
> 
> Changes in v2:
> - add support for optional regs / make syscon use optional
> - add device-tree changes for armada-388-clearfog
> - attempted to fix warning reported by krobot (untested)
> - tested on actual hardware
> - drafted dt-bindings
> - Link to v1: https://lore.kernel.org/r/20240715-a38x-utmi-phy-v1-0-d57250f53cf2@solid-run.com
> 
> ---
> Josua Mayer (6):
>       arm: dts: marvell: armada-388-clearfog: enable third usb on m.2/mpcie
>       arm: dts: marvell: armada-388-clearfog-base: add rfkill for m.2
>       dt-bindings: phy: cp110-utmi-phy: add compatible string for armada-38x
>       arm: dts: marvell: armada-38x: add description for usb phys
>       phy: mvebu-cp110-utmi: add support for armada-380 utmi phys
>       arm: dts: marvell: armada-388-clearfog: add description for usb phys
> 
>  .../phy/marvell,armada-cp110-utmi-phy.yaml         |  34 +++-
>  .../boot/dts/marvell/armada-388-clearfog-base.dts  |  41 ++++
>  arch/arm/boot/dts/marvell/armada-388-clearfog.dts  |   8 +
>  arch/arm/boot/dts/marvell/armada-388-clearfog.dtsi |  30 ++-
>  arch/arm/boot/dts/marvell/armada-38x.dtsi          |  24 +++
>  drivers/phy/marvell/phy-mvebu-cp110-utmi.c         | 209 ++++++++++++++++-----
>  6 files changed, 288 insertions(+), 58 deletions(-)
> ---
> base-commit: 1613e604df0cd359cf2a7fbd9be7a0bcfacfabd0
> change-id: 20240715-a38x-utmi-phy-02e8059afe35
> 
> Sincerely,
> --
> Josua Mayer <josua@solid-run.com>
> 
> 
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y marvell/armada-388-clearfog-base.dtb marvell/armada-388-clearfog.dtb' for 20240720-a38x-utmi-phy-v3-0-4c16f9abdbdc@solid-run.com:

arch/arm/boot/dts/marvell/armada-388-clearfog-base.dtb: usb@58000: phy-names:0: 'usb' was expected
	from schema $id: http://devicetree.org/schemas/usb/generic-ehci.yaml#
arch/arm/boot/dts/marvell/armada-388-clearfog.dtb: usb@58000: phy-names:0: 'usb' was expected
	from schema $id: http://devicetree.org/schemas/usb/generic-ehci.yaml#
arch/arm/boot/dts/marvell/armada-388-clearfog-base.dtb: usb3@f0000: Unevaluated properties are not allowed ('compatible', 'dr_mode', 'reg' were unexpected)
	from schema $id: http://devicetree.org/schemas/usb/generic-xhci.yaml#
arch/arm/boot/dts/marvell/armada-388-clearfog-base.dtb: usb3@f8000: Unevaluated properties are not allowed ('compatible', 'dr_mode', 'reg' were unexpected)
	from schema $id: http://devicetree.org/schemas/usb/generic-xhci.yaml#
arch/arm/boot/dts/marvell/armada-388-clearfog.dtb: usb3@f0000: Unevaluated properties are not allowed ('compatible', 'dr_mode', 'reg' were unexpected)
	from schema $id: http://devicetree.org/schemas/usb/generic-xhci.yaml#
arch/arm/boot/dts/marvell/armada-388-clearfog.dtb: usb3@f8000: Unevaluated properties are not allowed ('compatible', 'dr_mode', 'reg' were unexpected)
	from schema $id: http://devicetree.org/schemas/usb/generic-xhci.yaml#