Re: [PATCH v3 6/6] drm/rockchip: cdn-dp: remove the DP phy switch

[Heiko Stuebner <heiko@sntech.de>]

Am Freitag, 16. Februar 2018, 13:09:56 CET schrieb Enric Balletbo i Serra:
> From: Chris Zhong <zyw@rock-chips.com>
> 
> There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence
> only one PHY can connect to DP controller at one time, the other should
> be disconnected. The GRF_SOC_CON26 register has a switch bit to do it,
> set this bit means enable PHY 1, clear this bit means enable PHY 0.
> 
> If the board has 2 Type-C ports, the DP driver get the phy id from
> devm_of_phy_get_by_index, and then control this switch according to
> this id. But some others board only has one Type-C port, it may be PHY 0
> or PHY 1. The dts node id can not tell us the correct PHY id. Hence move
> this switch to PHY driver, the PHY driver can distinguish between PHY 0
> and PHY 1, and then write the correct register bit.
> 
> Signed-off-by: Chris Zhong <zyw@rock-chips.com>
> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>

applied to drm-misc with a note stating where the rest of the series
went to.

Thanks
Heiko