Re: [PATCH] arm64: dts: qcom: pm8916: add temp-alarm thermal zone

[Bryan O'Donoghue <bryan.odonoghue@linaro.org>]

On 25/06/2024 21:16, Dmitry Baryshkov wrote:
> Define the themal zones using the temperature values in stage1 for this
> platform so that the spmi-temp-alarm driver becomes active.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> ---
>   arch/arm64/boot/dts/qcom/pm8916.dtsi | 31 ++++++++++++++++++++++++++++++-
>   1 file changed, 30 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm8916.dtsi b/arch/arm64/boot/dts/qcom/pm8916.dtsi
> index 4b2e8fb47d2d..2def48f2d101 100644
> --- a/arch/arm64/boot/dts/qcom/pm8916.dtsi
> +++ b/arch/arm64/boot/dts/qcom/pm8916.dtsi
> @@ -4,8 +4,37 @@
>   #include <dt-bindings/interrupt-controller/irq.h>
>   #include <dt-bindings/spmi/spmi.h>
>   
> -&spmi_bus {
> +/ {
> +	thermal-zones {
> +		pm8150-thermal {
> +			polling-delay-passive = <100>;
> +
> +			thermal-sensors = <&pm8916_temp>;
> +
> +			trips {
> +				trip0 {
> +					temperature = <105000>;
> +					hysteresis = <0>;
> +					type = "passive";
> +				};
> +
> +				trip1 {
> +					temperature = <125000>;
> +					hysteresis = <0>;
> +					type = "hot";
> +				};
> +
> +				trip2 {
> +					temperature = <145000>;
> +					hysteresis = <0>;
> +					type = "critical";
> +				};
> +			};
> +		};
> +	};
> +};
145 c seemed amazingly hot to me but apparently this is the more 
conservative of the possible set.

https://git.codelinaro.org/clo/la/kernel/msm-3.10/-/blob/LA.BR.1.2.9.c26/Documentation/devicetree/bindings/thermal/qpnp-temp-alarm.txt?ref_type=heads#L28

Heating up even typing this email..

Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>