From: Grant Likely <grant.likely-s3s/WqlpOiPyB63q8FvJNQ@public.gmane.org>
To: Benoit Cousson <b-cousson-l0cyMroinI0@public.gmane.org>
Cc: khilman-l0cyMroinI0@public.gmane.org,
tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org,
manjugk-l0cyMroinI0@public.gmane.org,
devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org,
linux-omap-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
Charulatha V <charu-l0cyMroinI0@public.gmane.org>
Subject: Re: [RFC PATCH 09/10] arm/dts: OMAP4: Add gpio nodes
Date: Thu, 8 Sep 2011 11:16:20 -0700 [thread overview]
Message-ID: <20110908181620.GH2967@ponder.secretlab.ca> (raw)
In-Reply-To: <1314191356-10963-10-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
On Wed, Aug 24, 2011 at 03:09:15PM +0200, Benoit Cousson wrote:
> Add the 6 GPIOs controller nodes.
> Since the GPIO driver is still under cleanup, a couple of temp
> hacks are needed. They will be removed as soon as the driver will
> be cleaned.
>
> Remove gpio static device initialisation if CONFIG_OF is defined.
>
> Signed-off-by: Benoit Cousson <b-cousson-l0cyMroinI0@public.gmane.org>
> Cc: Grant Likely <grant.likely-s3s/WqlpOiPyB63q8FvJNQ@public.gmane.org>
> Cc: Charulatha V <charu-l0cyMroinI0@public.gmane.org>
> ---
> arch/arm/boot/dts/omap4.dtsi | 69 ++++++++++++++++++++++++++++++++++++++++++
> arch/arm/mach-omap2/gpio.c | 2 +
> 2 files changed, 71 insertions(+), 0 deletions(-)
>
> diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi
> index 231d7b4..f672927 100644
> --- a/arch/arm/boot/dts/omap4.dtsi
> +++ b/arch/arm/boot/dts/omap4.dtsi
> @@ -110,5 +110,74 @@
> compatible = "ti,omap-spinlock";
> hwmods = "spinlock";
> };
> +
> + gpio1: gpio@1 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio1";
> + /* id should not be needed with a global GPIO parent */
> + id = <1>;
> + bank_width = <32>;
> + debounce;
> + /* XXX: big hack until the bank_count is removed */
> + bank_count = <6>;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> +
> + gpio2: gpio@2 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio2";
> + id = <2>;
> + bank_width = <32>;
> + debounce;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> +
> + gpio3: gpio@3 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio3";
> + id = <3>;
> + bank_width = <32>;
> + debounce;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> +
> + gpio4: gpio@4 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio4";
> + id = <4>;
> + bank_width = <32>;
> + debounce;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> +
> + gpio5: gpio@5 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio5";
> + id = <5>;
> + bank_width = <32>;
> + debounce;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> +
> + gpio6: gpio@6 {
> + compatible = "ti,omap4-gpio", "ti,omap-gpio";
> + hwmods = "gpio6";
> + id = <6>;
> + bank_width = <32>;
> + debounce;
> + no_idle_on_suspend;
> + #gpio-cells = <2>;
> + gpio-controller;
> + };
> };
> };
> diff --git a/arch/arm/mach-omap2/gpio.c b/arch/arm/mach-omap2/gpio.c
> index 8cbfbc2..c51e952 100644
> --- a/arch/arm/mach-omap2/gpio.c
> +++ b/arch/arm/mach-omap2/gpio.c
> @@ -16,6 +16,7 @@
> * GNU General Public License for more details.
> */
>
> +#ifndef CONFIG_OF
> #include <linux/gpio.h>
> #include <linux/err.h>
> #include <linux/slab.h>
> @@ -126,3 +127,4 @@ static int __init omap2_gpio_init(void)
> NULL);
> }
> postcore_initcall(omap2_gpio_init);
> +#endif
Same as on earlier patch, don't #ifndef CONFIG_OF out non-DT code.
g.
> --
> 1.7.0.4
>
next prev parent reply other threads:[~2011-09-08 18:16 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-08-24 13:09 [RFC PATCH 00/10] OMAP: Add DT support for early init OMAP4 devices Benoit Cousson
2011-08-24 13:09 ` [RFC PATCH 04/10] arm/dts: OMAP4: Add mpu, dsp and iva nodes Benoit Cousson
[not found] ` <1314191356-10963-5-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:07 ` Grant Likely
2011-08-24 13:09 ` [RFC PATCH 05/10] documentation/dt: Add mpu, dsp and iva bindings Benoit Cousson
[not found] ` <1314191356-10963-6-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:09 ` Grant Likely
2011-09-09 0:30 ` Cousson, Benoit
2011-09-09 2:40 ` Grant Likely
[not found] ` <1314191356-10963-1-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-08-24 13:09 ` [RFC PATCH 01/10] OMAP2+: l3-noc: Add support for device-tree Benoit Cousson
2011-09-08 18:01 ` Grant Likely
[not found] ` <20110908180148.GA2967-e0URQFbLeQY2iJbIjFUEsiwD8/FfD2ys@public.gmane.org>
2011-09-08 21:59 ` Cousson, Benoit
2011-09-08 23:35 ` Grant Likely
2011-08-24 13:09 ` [RFC PATCH 02/10] arm/dts: OMAP4: Add a main ocp entry bound to l3-noc driver Benoit Cousson
[not found] ` <1314191356-10963-3-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:03 ` Grant Likely
2011-09-09 0:10 ` Cousson, Benoit
2011-09-09 2:41 ` Grant Likely
2011-08-24 13:09 ` [RFC PATCH 03/10] documentation/dt: Add l3-noc bindings Benoit Cousson
2011-09-08 18:06 ` Grant Likely
2011-09-09 0:18 ` Cousson, Benoit
2011-08-24 13:09 ` [RFC PATCH 06/10] hwspinlock: OMAP4: Add spinlock support in DT Benoit Cousson
2011-09-07 19:58 ` Ohad Ben-Cohen
2011-09-08 7:14 ` Cousson, Benoit
2011-09-08 7:56 ` Ohad Ben-Cohen
2011-09-08 8:07 ` Cousson, Benoit
2011-09-08 8:11 ` Ohad Ben-Cohen
2011-09-08 14:47 ` Arnd Bergmann
2011-09-08 15:34 ` Cousson, Benoit
[not found] ` <4E68E09B.4050006-l0cyMroinI0@public.gmane.org>
2011-09-08 16:03 ` Arnd Bergmann
[not found] ` <201109081647.55377.arnd-r2nGTMty4D4@public.gmane.org>
2011-09-08 16:36 ` Ohad Ben-Cohen
2011-09-09 12:58 ` Arnd Bergmann
2011-09-11 7:57 ` Ohad Ben-Cohen
2011-09-12 14:32 ` Arnd Bergmann
2011-08-24 13:09 ` [RFC PATCH 07/10] documentation/dt: Add spinlock bindings Benoit Cousson
[not found] ` <1314191356-10963-8-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:10 ` Grant Likely
2011-09-09 0:32 ` Cousson, Benoit
2011-08-24 13:09 ` [RFC PATCH 08/10] gpio/omap: Adapt GPIO driver to DT Benoit Cousson
[not found] ` <1314191356-10963-9-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:15 ` Grant Likely
2011-09-09 1:48 ` Cousson, Benoit
2011-08-24 13:09 ` [RFC PATCH 09/10] arm/dts: OMAP4: Add gpio nodes Benoit Cousson
[not found] ` <1314191356-10963-10-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:16 ` Grant Likely [this message]
2011-08-24 13:09 ` [RFC PATCH 10/10] documentation/dt: Add OMAP GPIO properties Benoit Cousson
[not found] ` <1314191356-10963-11-git-send-email-b-cousson-l0cyMroinI0@public.gmane.org>
2011-09-08 18:18 ` Grant Likely
2011-09-09 1:51 ` Cousson, Benoit
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20110908181620.GH2967@ponder.secretlab.ca \
--to=grant.likely-s3s/wqlpoipyb63q8fvjnq@public.gmane.org \
--cc=b-cousson-l0cyMroinI0@public.gmane.org \
--cc=charu-l0cyMroinI0@public.gmane.org \
--cc=devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org \
--cc=khilman-l0cyMroinI0@public.gmane.org \
--cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=linux-omap-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=manjugk-l0cyMroinI0@public.gmane.org \
--cc=tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).