Re: [PATCH 6/6] ARM: dts: Add device tree support for phycard pca100

[Markus Pargmann <mpa-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>]

On Thu, Jun 20, 2013 at 07:21:10PM +0400, Alexander Shiyan wrote:
> > Based on patches from:
> > 
> > Steffen Trumtrar <s.trumtrar-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>:
> >  - Original patch
> >  - ARM: dts: Set partition offsets for phycard
> >  - ARM: dts: Use CSPI1 instead of CSPI2 on phycard pca100
> >  - ARM: imx27-phytec-phycard-S.dts: resize nand partitions
> > 
> > Jan Luebbe <jlu-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>:
> >  - ARM: dts: Enable bad block table in NAND
> > 
> > Cc: Steffen Trumtrar <s.trumtrar-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> > Cc: Jan Luebbe <jlu-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> > Signed-off-by: Markus Pargmann <mpa-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> ...
> > +			gpio@10015000 {
> > +				status = "okay";
> > +			};
> > +
> > +			gpio@10015100 {
> > +				status = "okay";
> > +			};
> > +
> > +			gpio@10015200 {
> > +				status = "okay";
> > +			};
> > +
> > +			gpio@10015300 {
> > +				status = "okay";
> > +			};
> > +
> > +			gpio@10015400 {
> > +				status = "okay";
> > +			};
> > +
> > +			gpio@10015500 {
> > +				status = "okay";
> > +			};
> 
> No need setup status for devices which not disabled in imx27.dts

Thanks, I removed all unnecessary nodes, gpio and wdog.

Regards,

Markus

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |