From: Gerhard Sittig <gsi-ynQEQJNshbs@public.gmane.org>
To: Arnd Bergmann <arnd-r2nGTMty4D4@public.gmane.org>
Cc: devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
"Rob Herring@"
<rob.herring-bsGFqQB8/DxBDgjK7y7TUQ@public.gmane.org>,
Pawel Moll <Pawel.Moll-5wv7dgnIgG8@public.gmane.org>
Subject: Re: [PATCH v1 1/1] dt: binding: reword PowerPC 8xxx GPIO documentation
Date: Thu, 21 Nov 2013 09:34:38 +0100 [thread overview]
Message-ID: <20131121083438.GU17929@book.gsilab.sittig.org> (raw)
In-Reply-To: <201311210149.43944.arnd-r2nGTMty4D4@public.gmane.org>
On Thu, Nov 21, 2013 at 01:49 +0100, Arnd Bergmann wrote:
>
> On Wednesday 20 November 2013, Gerhard Sittig wrote:
> > re-format and re-word the device tree binding documentation for MPC8xxx
> > and compatibles, reference the common document for interrupt controllers
> > and remove outdated duplicate SoC specific information
> >
> > Cc: Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>
> > Cc: Rob Herring@ <rob.herring-bsGFqQB8/DxBDgjK7y7TUQ@public.gmane.org>
> > Cc: Pawel Moll <Pawel.Moll-5wv7dgnIgG8@public.gmane.org>
> > Cc: Arnd Bergmann <arnd-r2nGTMty4D4@public.gmane.org>
> > Cc: <devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org>
> > Signed-off-by: Gerhard Sittig <gsi-ynQEQJNshbs@public.gmane.org>
>
> Acked-by: Arnd Bergmann <arnd-r2nGTMty4D4@public.gmane.org>
thank you for the feedback and for the ACK
> > +Optional properties:
> > +- interrupt-controller: Empty boolean property which marks the GPIO
> > + module as an IRQ controller.
> > +- #interrupt-cells: Number of integer cells required to specify an
> > + interrupt within this interrupt controller. The
> > + first cell defines the pin number, the second
> > + cell defines additional flags (trigger type,
> > + trigger polarity). Note that the specific set
> > + of trigger conditions supported by the GPIO
> > + module depends on the actual SoC.
>
> Nitpicking: I think you need to add that #interrupt-cells must be <2>
> if present. I'd also suggest adding these two to the example section
> of the binding while you're at it.
will do
and I assume that your ACK still applies after I have addressed
the feedback from you and from Rob
virtually yours
Gerhard Sittig
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr. 5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office-ynQEQJNshbs@public.gmane.org
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2013-11-21 8:34 UTC|newest]
Thread overview: 21+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-14 21:46 [PATCH 0/3] Add EOC handling for bmp085 + DT and platform data updates Marek Belisko
[not found] ` <1384465609-26485-1-git-send-email-marek-xXXSsgcRVICgSpxsJD1C4w@public.gmane.org>
2013-11-14 21:46 ` [PATCH 1/3] misc: bmp085: Clean up and enable use of interrupt for completion Marek Belisko
2013-11-14 21:46 ` [PATCH 2/3] misc: bmp085: Add DT bindings for EOC gpio line and direct irq Marek Belisko
2013-11-15 13:56 ` Arnd Bergmann
2013-11-15 15:30 ` Mark Rutland
2013-11-15 18:47 ` Arnd Bergmann
2013-11-18 8:58 ` Belisko Marek
[not found] ` <CAAfyv346pUa9k3+9jdBX+EK8cV9GenaBxrAnVnKsbUPBoNBqrQ-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2013-11-18 11:38 ` Arnd Bergmann
[not found] ` <201311181238.40349.arnd-r2nGTMty4D4@public.gmane.org>
2013-11-18 17:17 ` Gerhard Sittig
[not found] ` <20131118171747.GM17929-kDjWylLy9wD0K7fsECOQyeGNnDKD8DIp@public.gmane.org>
2013-11-18 22:28 ` Arnd Bergmann
[not found] ` <201311182328.40743.arnd-r2nGTMty4D4@public.gmane.org>
2013-11-20 21:34 ` [PATCH v1 1/1] dt: binding: reword PowerPC 8xxx GPIO documentation Gerhard Sittig
[not found] ` <1384983293-11002-1-git-send-email-gsi-ynQEQJNshbs@public.gmane.org>
2013-11-20 23:50 ` Rob Herring
[not found] ` <CAL_JsqJvxA240QEreWPp2L+eNFQmhp0XV=qmO4QXqTga+RFuCQ-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2013-11-21 8:30 ` Gerhard Sittig
2013-11-21 0:49 ` Arnd Bergmann
[not found] ` <201311210149.43944.arnd-r2nGTMty4D4@public.gmane.org>
2013-11-21 8:34 ` Gerhard Sittig [this message]
2013-11-21 8:41 ` [PATCH v2 " Gerhard Sittig
[not found] ` <1385023304-15396-1-git-send-email-gsi-ynQEQJNshbs@public.gmane.org>
2013-12-03 6:02 ` Rob Herring
2013-11-20 23:23 ` [PATCH 2/3] misc: bmp085: Add DT bindings for EOC gpio line and direct irq Gerhard Sittig
2013-11-14 21:46 ` [PATCH 3/3] misc: bmp085: Add missing platform data Marek Belisko
2013-11-15 13:58 ` Arnd Bergmann
2013-11-16 8:23 ` Dr. H. Nikolaus Schaller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131121083438.GU17929@book.gsilab.sittig.org \
--to=gsi-ynqeqjnshbs@public.gmane.org \
--cc=Pawel.Moll-5wv7dgnIgG8@public.gmane.org \
--cc=arnd-r2nGTMty4D4@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=rob.herring-bsGFqQB8/DxBDgjK7y7TUQ@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).