From: Guenter Roeck <linux@roeck-us.net>
To: Arnaud Ebalard <arno@natisbad.org>
Cc: Mark Rutland <mark.rutland@arm.com>,
Alessandro Zummo <a.zummo@towertech.it>,
Peter Huewe <peter.huewe@infineon.com>,
Linus Walleij <linus.walleij@linaro.org>,
Thierry Reding <treding@nvidia.com>,
Mark Brown <broonie@kernel.org>,
Rob Herring <rob.herring@calxeda.com>,
Pawel Moll <pawel.moll@arm.com>,
Stephen Warren <swarren@wwwdotorg.org>,
Ian Campbell <ijc+devicetree@hellion.org.uk>,
Grant Likely <grant.likely@linaro.org>,
devicetree@vger.kernel.org, linux-doc@vger.kernel.org,
Rob Landley <rob@landley.net>,
rtc-linux@googlegroups.com, Jason Cooper <jason@lakedaemon.net>,
Jason Gunthorpe <jgunthorpe@obsidianresearch.com>,
Kumar Gala <galak@codeaurora.org>,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCHv4] rtc: Add support for Intersil ISL12057 I2C RTC chip
Date: Mon, 16 Dec 2013 14:38:04 -0800 [thread overview]
Message-ID: <20131216223804.GA10162@roeck-us.net> (raw)
In-Reply-To: <87mwk0l9j2.fsf@natisbad.org>
On Mon, Dec 16, 2013 at 11:24:01PM +0100, Arnaud Ebalard wrote:
> Hi Guenter,
>
> Guenter Roeck <linux@roeck-us.net> writes:
>
> > On Mon, Dec 16, 2013 at 10:17:47PM +0100, Arnaud Ebalard wrote:
> >>
> >> Intersil ISL12057 I2C RTC chip also supports two alarms. This patch
> >> only adds support for basic RTC functionalities (i.e. getting and
> >> setting time). Tests have been performed on NETGEAR ReadyNAS 102 w/
> >> startup/shutdown scripts, hwclock, ntpdate and openntpd.
> >>
> >> Signed-off-by: Arnaud Ebalard <arno@natisbad.org>
> >
> > Here is a snippet from the saved patch:
> >
> > obj-$(CONFIG_RTC_DRV_IMXDI) +=3D rtc-imxdi.o
> > obj-$(CONFIG_RTC_DRV_ISL1208) +=3D rtc-isl1208.o
> > obj-$(CONFIG_RTC_DRV_ISL12022) +=3D rtc-isl12022.o
> > +obj-$(CONFIG_RTC_DRV_ISL12057) +=3D rtc-isl12057.o
> > obj-$(CONFIG_RTC_DRV_JZ4740) +=3D rtc-jz4740.o
> > obj-$(CONFIG_RTC_DRV_LP8788) +=3D rtc-lp8788.o
> > obj-$(CONFIG_RTC_DRV_LPC32XX) +=3D rtc-lpc32xx.o
> >
> > Something is adding those '3D' after each '=' into the patch.
>
> Well, I simply use git-imap-send to send the patch to my IMAP draft
> folder and then sent it from my mailer (Gnus/5.13 for Emacs/24.3).
>
> What is very weird is that if I simply save the mail I received from
> LAKML (I am registered to LAKML which I have put in Cc:), checkptach
> gives me the following (my checkpatch.pl is the one in 3.13.0.rc4):
>
> $ ./scripts/checkpatch.pl /tmp/v4.patch ERROR: Do not include the
> paragraph about writing to the Free Software Foundation's mailing
> address from the sample GPL notice. The FSF has changed addresses in the
> past, and may do so again. Linux already includes a copy of the GPL.
> #165: FILE: drivers/rtc/rtc-isl12057.c:23:
> + * You should have received a copy of the GNU General Public License$
>
> ERROR: Do not include the paragraph about writing to the Free Software
> Foundation's mailing address from the sample GPL notice. The FSF has
> changed addresses in the past, and may do so again. Linux already
> includes a copy of the GPL.
> #166: FILE: drivers/rtc/rtc-isl12057.c:24:
> + * along with this program; if not, write to the Free Software$
>
> total: 2 errors, 0 warnings, 396 lines checked
>
> /tmp/v4.patch has style problems, please review.
>
> If any of these errors are false positives, please report
> them to the maintainer, see CHECKPATCH in MAINTAINERS.
>
> Those false/positive are the only error checkptach reports on my side
> for the patch. This is the same if I copy/paste the content of the
> <pre></pre> with the patch in the following page:
>
> http://www.spinics.net/lists/arm-kernel/msg294759.html.
>
> I do not say you are wrong but I do not have a clue were the problem
> may come from.
>
Oddly enough me not either. Let's assume the problem was on my side.
I sent you another round of comments a bit ago.
Thanks,
Guenter
next prev parent reply other threads:[~2013-12-16 22:38 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-12-16 21:17 [PATCHv4] rtc: Add support for Intersil ISL12057 I2C RTC chip Arnaud Ebalard
2013-12-16 21:37 ` Guenter Roeck
2013-12-16 22:24 ` Arnaud Ebalard
2013-12-16 22:38 ` Guenter Roeck [this message]
2013-12-16 23:23 ` Mark Brown
2013-12-16 22:18 ` Guenter Roeck
2013-12-16 22:36 ` Arnaud Ebalard
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131216223804.GA10162@roeck-us.net \
--to=linux@roeck-us.net \
--cc=a.zummo@towertech.it \
--cc=arno@natisbad.org \
--cc=broonie@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=grant.likely@linaro.org \
--cc=ijc+devicetree@hellion.org.uk \
--cc=jason@lakedaemon.net \
--cc=jgunthorpe@obsidianresearch.com \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-doc@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=pawel.moll@arm.com \
--cc=peter.huewe@infineon.com \
--cc=rob.herring@calxeda.com \
--cc=rob@landley.net \
--cc=rtc-linux@googlegroups.com \
--cc=swarren@wwwdotorg.org \
--cc=treding@nvidia.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).