Re: [net-next,PATCH v6 7/8] net: stmmac: dwmac-stm32: Mask support for PMCR configuration

[Marek Vasut <marex@denx.de>]

On 6/10/24 9:14 AM, Christophe Roullier wrote:

[...]

>   static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
> @@ -303,7 +307,7 @@ static int stm32mcu_set_mode(struct plat_stmmacenet_data *plat_dat)
>   	dev_dbg(dwmac->dev, "Mode %s", phy_modes(plat_dat->mac_interface));
>   
>   	return regmap_update_bits(dwmac->regmap, reg,
> -				 dwmac->ops->syscfg_eth_mask, val << 23);
> +				 SYSCFG_MCU_ETH_MASK, val << 23);
>   }
>   
>   static void stm32_dwmac_clk_disable(struct stm32_dwmac *dwmac, bool suspend)
> @@ -348,8 +352,15 @@ static int stm32_dwmac_parse_data(struct stm32_dwmac *dwmac,
>   		return PTR_ERR(dwmac->regmap);
>   
>   	err = of_property_read_u32_index(np, "st,syscon", 1, &dwmac->mode_reg);
> -	if (err)
> +	if (err) {
>   		dev_err(dev, "Can't get sysconfig mode offset (%d)\n", err);
> +		return err;
> +	}
> +
> +	dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
> +	err = of_property_read_u32_index(np, "st,syscon", 2, &dwmac->mode_mask);
> +	if (err)
> +		dev_dbg(dev, "Warning sysconfig register mask not set\n");

Isn't this an error , so dev_err() ?

Include the err variable in the error message, see the dev_err() above 
for an example. That way the log already contains useful information 
(the error code) that can be used to narrow down the problem.