From: Felipe Balbi <balbi@ti.com>
To: Suman Anna <s-anna@ti.com>
Cc: Ohad Ben-Cohen <ohad@wizery.com>,
Mark Rutland <mark.rutland@arm.com>,
devicetree@vger.kernel.org, Tony Lindgren <tony@atomide.com>,
linux-kernel@vger.kernel.org, Kumar Gala <galak@codeaurora.org>,
linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCHv4 6/7] hwspinlock/omap: enable module before reading SYSSTATUS register
Date: Tue, 14 Jan 2014 07:10:52 -0600 [thread overview]
Message-ID: <20140114131052.GA10818@saruman.home> (raw)
In-Reply-To: <1389658764-39199-7-git-send-email-s-anna@ti.com>
[-- Attachment #1.1: Type: text/plain, Size: 1774 bytes --]
On Mon, Jan 13, 2014 at 06:19:23PM -0600, Suman Anna wrote:
> The number of hwspinlocks are determined based on the value read
> from the IP block's SYSSTATUS register. However, the module may
> not be enabled and clocked, and the read may result in a bus error.
>
> This particular issue is seen rather easily on AM33XX, since the
> module wakeup is software controlled, and it is disabled out of
> reset. Make sure the module is enabled and clocked before reading
> the SYSSTATUS register.
>
> Signed-off-by: Suman Anna <s-anna@ti.com>
> ---
> drivers/hwspinlock/omap_hwspinlock.c | 21 ++++++++++++++-------
> 1 file changed, 14 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/hwspinlock/omap_hwspinlock.c b/drivers/hwspinlock/omap_hwspinlock.c
> index 9f56fb2..194886e 100644
> --- a/drivers/hwspinlock/omap_hwspinlock.c
> +++ b/drivers/hwspinlock/omap_hwspinlock.c
> @@ -101,10 +101,23 @@ static int omap_hwspinlock_probe(struct platform_device *pdev)
> if (!io_base)
> return -ENOMEM;
>
> + /*
> + * make sure the module is enabled and clocked before reading
> + * the module SYSSTATUS register
> + */
> + pm_runtime_enable(&pdev->dev);
> + pm_runtime_get_sync(&pdev->dev);
> +
> /* Determine number of locks */
> i = readl(io_base + SYSSTATUS_OFFSET);
> i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET;
>
> + /*
> + * runtime PM will make sure the clock of this module is
> + * enabled again iff at least one lock is requested
> + */
> + pm_runtime_put(&pdev->dev);
there is a small race here (which was already present previously) where
you could return from probe() in a failure case before your PM runtime
put request then you would disable pm_runtime while the device was still
alive.
--
balbi
[-- Attachment #1.2: Digital signature --]
[-- Type: application/pgp-signature, Size: 819 bytes --]
[-- Attachment #2: Type: text/plain, Size: 176 bytes --]
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2014-01-14 13:10 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-01-14 0:19 [PATCHv4 0/7] omap hwspinlock dt support Suman Anna
2014-01-14 0:19 ` [PATCHv4 1/7] Documentation: dt: add common bindings for hwspinlock Suman Anna
2014-01-14 0:19 ` [PATCHv4 2/7] Documentation: dt: add the omap hwspinlock bindings document Suman Anna
2014-01-14 0:19 ` [PATCHv4 3/7] hwspinlock/core: maintain a list of registered hwspinlock banks Suman Anna
2014-01-14 0:19 ` [PATCHv4 4/7] hwspinlock/core: add common OF helpers Suman Anna
2014-02-07 22:49 ` Bjorn Andersson
2014-02-10 19:14 ` Suman Anna
2014-03-02 5:14 ` Ohad Ben-Cohen
2014-03-02 20:19 ` Bjorn Andersson
2014-03-03 18:46 ` Suman Anna
[not found] ` <CAJAp7Ohf43hbKatCwS5Y1+OfEkJYWOkuhZhW-E_=t_9mfM+UaA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-03-04 17:38 ` Suman Anna
[not found] ` <53160F8F.9060405-l0cyMroinI0@public.gmane.org>
2014-03-13 16:43 ` Josh Cartwright
2014-03-14 8:58 ` Ohad Ben-Cohen
2014-03-14 13:12 ` Ohad Ben-Cohen
2014-03-14 15:23 ` Josh Cartwright
2014-03-15 17:32 ` Ohad Ben-Cohen
2014-09-26 14:40 ` Bjorn Andersson
2014-09-26 16:25 ` Suman Anna
[not found] ` <5425938C.6070007-l0cyMroinI0@public.gmane.org>
2014-10-06 9:44 ` Ohad Ben-Cohen
[not found] ` <CAK=WgbYf3++K4MVXW_n4zj-8fMEee61XG5+r40cW=trapRtJ7w-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-11-06 18:24 ` Suman Anna
[not found] ` <545BBCCB.7030107-l0cyMroinI0@public.gmane.org>
2014-11-07 5:06 ` Ohad Ben-Cohen
2014-01-14 0:19 ` [PATCHv4 6/7] hwspinlock/omap: enable module before reading SYSSTATUS register Suman Anna
2014-01-14 13:10 ` Felipe Balbi [this message]
2014-01-14 14:04 ` Felipe Balbi
[not found] ` <20140114140440.GA15785-HgARHv6XitL9zxVx7UNMDg@public.gmane.org>
2014-01-14 16:56 ` Anna, Suman
2014-01-15 23:46 ` Anna, Suman
2014-01-15 23:36 ` [UPDATED PATCHv4 " Suman Anna
2014-01-14 0:19 ` [PATCHv4 7/7] hwspinlock/omap: enable build for AM33xx, AM43xx & DRA7xx Suman Anna
2014-01-14 13:12 ` Felipe Balbi
2014-01-14 16:51 ` Anna, Suman
2014-01-14 17:29 ` Felipe Balbi
2014-01-14 18:36 ` Anna, Suman
2014-01-14 13:12 ` [PATCHv4 0/7] omap hwspinlock dt support Felipe Balbi
[not found] ` <1389658764-39199-1-git-send-email-s-anna-l0cyMroinI0@public.gmane.org>
2014-01-14 0:19 ` [PATCHv4 5/7] hwspinlock/omap: add support for dt nodes Suman Anna
2014-02-10 19:27 ` [PATCHv4 0/7] omap hwspinlock dt support Suman Anna
2014-02-24 18:14 ` Suman Anna
[not found] ` <530B8C00.8020001-l0cyMroinI0@public.gmane.org>
2014-03-14 20:10 ` Ohad Ben-Cohen
[not found] ` <CAK=WgbZp_RQPCeZJyMRkNTQxaJsnGZ3DnjhSkYYR_-PAE_Kp4g-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-03-14 23:58 ` Suman Anna
2014-03-17 14:23 ` Ohad Ben-Cohen
[not found] ` <CAK=WgbZCzA7JovSxnysHCQRZZWc3Z2j3AS8ekpM9fOZ160rmCA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2014-03-17 19:10 ` Suman Anna
[not found] ` <532748B7.1080606-l0cyMroinI0@public.gmane.org>
2014-03-17 19:47 ` Ohad Ben-Cohen
2014-03-17 23:46 ` Suman Anna
[not found] ` <53278950.5030905-l0cyMroinI0@public.gmane.org>
2014-03-18 13:35 ` Ohad Ben-Cohen
2014-03-31 22:45 ` Suman Anna
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140114131052.GA10818@saruman.home \
--to=balbi@ti.com \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=ohad@wizery.com \
--cc=s-anna@ti.com \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).