Re: [PATCH v3 0/5] Add Broadcom Kona PWM Support

[Matt Porter <mporter@linaro.org>]

On Wed, Mar 12, 2014 at 01:15:41PM -0700, Tim Kryger wrote:
> This series introduces the driver for the Kona PWM controller found in
> Broadcom mobile SoCs like bcm281xx and updates the device tree and the
> defconfig to enable use of this hardware on the bcm28155 AP board.
> 
> Changes since v2:
>   - SoC DTS file updated to use real clock's phandle + specifier
>   - Toggle smooth mode off during apply so new settings take immediately
> 
> Changes since v1:
>   - Fixed up macros to be clearer and more complete
>   - Corrected spelling and punctuation mistakes
>   - Added support for polarity
>   - Made peripheral clock use more efficient
>   - Made prescale and duty computation clearer
>   - Moved Makefile addition to keep alphabetical
>   - Split complex lines into multiple steps
> 
> Dependencies:
> The "ARM: dts: Declare the PWM for bcm11351 (bcm281xx)" patch depends
> upon "ARM: dts: bcm281xx: define real clocks" which is queued up in
> for-next of arm-soc. See https://lkml.org/lkml/2014/2/14/451
> 
> Tim Kryger (5):
>   Documentation: dt: Add Kona PWM binding
>   pwm: kona: Introduce Kona PWM controller support

Thierry, are you planning to merge these first two for 3.15? If so, I
will apply dts patches for my last mach-bcm 3.15 pull. I don't want to
do so until the binding is accepted.

-Matt

>   ARM: dts: Declare the PWM for bcm11351 (bcm281xx)
>   ARM: dts: Enable the PWM for bcm28155 AP board
>   ARM: bcm_defconfig: Enable PWM and Backlight