From: Lee Jones <lee.jones@linaro.org>
To: Inha Song <ideal.song@samsung.com>
Cc: devicetree@vger.kernel.org, alsa-devel@alsa-project.org,
linux-kernel@vger.kernel.org,
patches@opensource.wolfsonmicro.com, cw00.choi@samsung.com,
broonie@kernel.org, ckeepax@opensource.wolfsonmicro.com,
rf@opensource.wolfsonmicro.com, robh+dt@kernel.org,
pawel.moll@arm.com, mark.rutland@arm.com,
ijc+devicetree@hellion.org.uk
Subject: Re: [alsa-devel] [PATCH v4 1/2] extcon: arizona: Add support for select accessory detect mode when headphone detection
Date: Thu, 30 Apr 2015 11:16:41 +0100 [thread overview]
Message-ID: <20150430101641.GF1815@x1> (raw)
In-Reply-To: <1430357878-22859-2-git-send-email-ideal.song@samsung.com>
On Thu, 30 Apr 2015, Inha Song wrote:
> This patch add support for select accessory detect mode to HPDETL or HPDETR.
> Arizona provides a headphone detection circuit on the HPDETL and HPDETR pins
> to measure the impedance of an external load connected to the headphone.
>
> Depending on board design, headphone detect pins can change to HPDETR or HPDETL.
>
> Signed-off-by: Inha Song <ideal.song@samsung.com>
> ---
> drivers/extcon/extcon-arizona.c | 38 ++++++++++++++++++++++++++++++--------
> include/dt-bindings/mfd/arizona.h | 8 ++++++++
> include/linux/mfd/arizona/pdata.h | 3 +++
> 3 files changed, 41 insertions(+), 8 deletions(-)
> create mode 100644 include/dt-bindings/mfd/arizona.h
>
> diff --git a/drivers/extcon/extcon-arizona.c b/drivers/extcon/extcon-arizona.c
> index 63f01c4..d251e92 100644
> --- a/drivers/extcon/extcon-arizona.c
> +++ b/drivers/extcon/extcon-arizona.c
> @@ -32,13 +32,10 @@
> #include <linux/mfd/arizona/core.h>
> #include <linux/mfd/arizona/pdata.h>
> #include <linux/mfd/arizona/registers.h>
> +#include <dt-bindings/mfd/arizona.h>
>
> #define ARIZONA_MAX_MICD_RANGE 8
>
> -#define ARIZONA_ACCDET_MODE_MIC 0
> -#define ARIZONA_ACCDET_MODE_HPL 1
> -#define ARIZONA_ACCDET_MODE_HPR 2
> -
> #define ARIZONA_MICD_CLAMP_MODE_JDL 0x4
> #define ARIZONA_MICD_CLAMP_MODE_JDH 0x5
> #define ARIZONA_MICD_CLAMP_MODE_JDL_GP5H 0x9
> @@ -653,9 +650,9 @@ static void arizona_identify_headphone(struct arizona_extcon_info *info)
> ret = regmap_update_bits(arizona->regmap,
> ARIZONA_ACCESSORY_DETECT_MODE_1,
> ARIZONA_ACCDET_MODE_MASK,
> - ARIZONA_ACCDET_MODE_HPL);
> + arizona->pdata.hpdet_channel);
> if (ret != 0) {
> - dev_err(arizona->dev, "Failed to set HPDETL mode: %d\n", ret);
> + dev_err(arizona->dev, "Failed to set HPDET mode: %d\n", ret);
> goto err;
> }
>
> @@ -705,9 +702,9 @@ static void arizona_start_hpdet_acc_id(struct arizona_extcon_info *info)
> ARIZONA_ACCESSORY_DETECT_MODE_1,
> ARIZONA_ACCDET_SRC | ARIZONA_ACCDET_MODE_MASK,
> info->micd_modes[0].src |
> - ARIZONA_ACCDET_MODE_HPL);
> + arizona->pdata.hpdet_channel);
> if (ret != 0) {
> - dev_err(arizona->dev, "Failed to set HPDETL mode: %d\n", ret);
> + dev_err(arizona->dev, "Failed to set HPDET mode: %d\n", ret);
> goto err;
> }
>
> @@ -1103,6 +1100,26 @@ static void arizona_micd_set_level(struct arizona *arizona, int index,
> regmap_update_bits(arizona->regmap, reg, mask, level);
> }
>
> +static int arizona_extcon_of_get_pdata(struct arizona *arizona)
> +{
> + struct arizona_pdata *pdata = &arizona->pdata;
> + unsigned int val = ARIZONA_ACCDET_MODE_HPL;
> +
> + of_property_read_u32(arizona->dev->of_node, "wlf,hpdet-channel", &val);
> + switch (val) {
> + case ARIZONA_ACCDET_MODE_HPL:
> + case ARIZONA_ACCDET_MODE_HPR:
> + pdata->hpdet_channel = val;
> + break;
> + default:
> + dev_err(arizona->dev,
> + "Wrong wlf,hpdet-channel DT value %d\n", val);
> + pdata->hpdet_channel = ARIZONA_ACCDET_MODE_HPL;
> + }
> +
> + return 0;
> +}
> +
> static int arizona_extcon_probe(struct platform_device *pdev)
> {
> struct arizona *arizona = dev_get_drvdata(pdev->dev.parent);
> @@ -1120,6 +1137,11 @@ static int arizona_extcon_probe(struct platform_device *pdev)
> if (!info)
> return -ENOMEM;
>
> + if (IS_ENABLED(CONFIG_OF)) {
> + if (!dev_get_platdata(arizona->dev))
> + arizona_extcon_of_get_pdata(arizona);
> + }
> +
> info->micvdd = devm_regulator_get(&pdev->dev, "MICVDD");
> if (IS_ERR(info->micvdd)) {
> ret = PTR_ERR(info->micvdd);
> diff --git a/include/dt-bindings/mfd/arizona.h b/include/dt-bindings/mfd/arizona.h
> new file mode 100644
> index 0000000..9ecff78
> --- /dev/null
> +++ b/include/dt-bindings/mfd/arizona.h
> @@ -0,0 +1,8 @@
> +#ifndef __DT_BINDINGS_ARIZONA_H__
> +#define __DT_BINDINGS_ARIZONA_H__
> +
> +#define ARIZONA_ACCDET_MODE_MIC 0
> +#define ARIZONA_ACCDET_MODE_HPL 1
> +#define ARIZONA_ACCDET_MODE_HPR 2
> +
> +#endif /* __DT_BINDINGS_ARIZONA_H__ */
> diff --git a/include/linux/mfd/arizona/pdata.h b/include/linux/mfd/arizona/pdata.h
> index 4578c72..2473a67 100644
> --- a/include/linux/mfd/arizona/pdata.h
> +++ b/include/linux/mfd/arizona/pdata.h
> @@ -139,6 +139,9 @@ struct arizona_pdata {
> /** GPIO used for mic isolation with HPDET */
> int hpdet_id_gpio;
>
> + /** Channel to use for headphone detection */
> + unsigned int hpdet_channel;
> +
Not sure why this file is using kerneldoc comments.
Acked-by: Lee Jones <lee.jones@linaro.org>
> /** Extra debounce timeout used during initial mic detection (ms) */
> int micd_detect_debounce;
>
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
next prev parent reply other threads:[~2015-04-30 10:16 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-04-30 1:37 [alsa-devel] [PATCH v4 0/2] Add support for select accessory detect mode to HPDETL or HPDETR Inha Song
2015-04-30 1:37 ` [alsa-devel] [PATCH v4 1/2] extcon: arizona: Add support for select accessory detect mode when headphone detection Inha Song
[not found] ` <1430357878-22859-2-git-send-email-ideal.song-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2015-04-30 9:32 ` Charles Keepax
2015-04-30 10:16 ` Chanwoo Choi
2015-04-30 10:16 ` Lee Jones [this message]
2015-04-30 1:37 ` [alsa-devel] [PATCH v4 2/2] mfd: arizona: Update DT binding to support hpdet channel Inha Song
[not found] ` <1430357878-22859-3-git-send-email-ideal.song-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2015-04-30 9:32 ` Charles Keepax
2015-04-30 10:09 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150430101641.GF1815@x1 \
--to=lee.jones@linaro.org \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@kernel.org \
--cc=ckeepax@opensource.wolfsonmicro.com \
--cc=cw00.choi@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=ideal.song@samsung.com \
--cc=ijc+devicetree@hellion.org.uk \
--cc=linux-kernel@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=patches@opensource.wolfsonmicro.com \
--cc=pawel.moll@arm.com \
--cc=rf@opensource.wolfsonmicro.com \
--cc=robh+dt@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).