From: Lee Jones <lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
To: Charles Keepax
<ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
Cc: cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
pawel.moll-5wv7dgnIgG8@public.gmane.org,
mark.rutland-5wv7dgnIgG8@public.gmane.org,
ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org,
galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org,
myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
patches-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org
Subject: Re: [PATCH v2 4/5] mfd: arizona: Update DT binding documentation for mic detection
Date: Tue, 13 Oct 2015 14:43:02 +0100 [thread overview]
Message-ID: <20151013134302.GA32409@x1> (raw)
In-Reply-To: <20151013121530.GE8805@ck-lbox>
On Tue, 13 Oct 2015, Charles Keepax wrote:
> On Tue, Oct 13, 2015 at 09:08:00AM +0100, Lee Jones wrote:
> > On Fri, 02 Oct 2015, Charles Keepax wrote:
> >
> > > Add additional bindings to allow configuration of the system specific
> > > microphone detection settings.
> > >
> > > Signed-off-by: Charles Keepax <ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxiMEWR6Nv5iY@public.gmane.orgm>
> > > ---
> > > Documentation/devicetree/bindings/mfd/arizona.txt | 21 +++++++++++++++++++++
> > > include/dt-bindings/mfd/arizona.h | 5 +++++
> > > 2 files changed, 26 insertions(+), 0 deletions(-)
> > >
> > > diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
> > > index a8fee60..b98a11b 100644
> > > --- a/Documentation/devicetree/bindings/mfd/arizona.txt
> > > +++ b/Documentation/devicetree/bindings/mfd/arizona.txt
> > > @@ -73,6 +73,27 @@ Optional properties:
> > > If this node is not mentioned or if the value is unknown, then
> > > headphone detection mode is set to HPDETL.
> > >
> > > + - wlf,micd-software-compare : Use a software comparison to determine mic
> > > + presence
> > > + - wlf,micd-detect-debounce : Additional software microphone detection
> > > + debounce specified in milliseconds.
> > > + - wlf,micd-pol-gpio : GPIO specifier for the GPIO controlling the headset
> > > + polarity if one exists.
> > > + - wlf,micd-bias-start-time : Time allowed for MICBIAS to startup prior to
> > > + performing microphone detection, specified as per the ARIZONA_MICD_TIME_XXX
> > > + defines.
> > > + - wlf,micd-rate : Delay between successive microphone detection measurements,
> > > + specified as per the ARIZONA_MICD_TIME_XXX defines.
> > > + - wlf,micd-dbtime : Microphone detection hardware debounces specified as the
> > > + number of measurements to take, valid values being 2 and 4.
> > > + - wlf,micd-timeout : Timeout for microphone detection, specified in
> > > + milliseconds.
> > > + - wlf,micd-force-micbias : Force MICBIAS continuously on during microphone
> > > + detection.
> > > +
> > > + - wlf,gpsw : Settings for the general purpose switch, set as one of the
> > > + ARIZONA_GPSW_XXX defines.
> >
> > Where are all of these bindings to be consumed?
>
> In the extcon driver it handles all jack detection in the Arizona
> devices.
Okay, perfect. Please move them to the Extcon doc. :)
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2015-10-13 13:43 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-10-02 16:29 [PATCH v2 0/5] Arizona Extcon Update Device Bindings Charles Keepax
[not found] ` <1443803363-3251-1-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-10-02 16:29 ` [PATCH v2 1/5] extcon: arizona: Add device binding to enable ADC mode micdet Charles Keepax
2015-10-02 16:29 ` [PATCH v2 2/5] extcon: arizona: Add device binding for the general purpose switch Charles Keepax
2015-10-02 16:29 ` [PATCH v2 3/5] extcon: arizona: Add device binding for jack detect polarity inversion Charles Keepax
2015-10-02 16:29 ` [PATCH v2 4/5] mfd: arizona: Update DT binding documentation for mic detection Charles Keepax
2015-10-05 10:02 ` Lee Jones
2015-10-07 10:00 ` Mark Brown
[not found] ` <20151007100017.GB12635-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
2015-10-07 12:26 ` Lee Jones
2015-10-12 8:45 ` Charles Keepax
2015-10-12 10:16 ` Chanwoo Choi
2015-10-12 10:25 ` Chanwoo Choi
2015-10-13 8:03 ` Lee Jones
2015-10-13 10:11 ` Chanwoo Choi
2015-10-12 13:43 ` Mark Brown
[not found] ` <20151012134309.GE1542-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
2015-10-13 8:02 ` Lee Jones
2015-10-13 12:14 ` Charles Keepax
2015-10-13 13:50 ` Lee Jones
2015-10-13 13:59 ` Chanwoo Choi
[not found] ` <561D0E4C.4010205-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2015-10-13 14:09 ` Chanwoo Choi
2015-10-13 14:18 ` Lee Jones
2015-10-13 15:23 ` Charles Keepax
2015-10-13 15:12 ` Mark Brown
2015-10-14 7:28 ` Lee Jones
2015-10-14 9:49 ` Mark Brown
[not found] ` <20151014094903.GP14956-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
2015-10-14 12:30 ` Lee Jones
2015-10-14 13:09 ` Mark Brown
2015-10-14 13:20 ` Lee Jones
2015-10-13 8:08 ` Lee Jones
2015-10-13 12:15 ` Charles Keepax
2015-10-13 13:43 ` Lee Jones [this message]
2015-10-02 16:29 ` [PATCH v2 5/5] mfd: arizona: Update DT binding document for jack detection invert Charles Keepax
2015-10-05 10:01 ` Lee Jones
2015-10-12 8:15 ` Charles Keepax
2015-10-13 8:07 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20151013134302.GA32409@x1 \
--to=lee.jones-qsej5fyqhm4dnm+yrofe0a@public.gmane.org \
--cc=broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org \
--cc=cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
--cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=patches-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org \
--cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).