[PATCH v2 5/5] ARM: dts: sun8i: Add THS node to the H3 .dtsi

Josef Gajdusek
2015-11-23T08:02:52Z

This patch adds nodes for the THS driver and the THS clock to the Allwinner
H3 .dtsi file.

Signed-off-by: Josef Gajdusek <atx-MwjtXicnQwU@public.gmane.org>
---
arch/arm/boot/dts/sun8i-h3.dtsi | 33 +++++++++++++++++++++++++++++++++
1 file changed, 33 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
index 58de718..48500d4 100644
--- a/arch/arm/boot/dts/sun8i-h3.dtsi
+++ b/arch/arm/boot/dts/sun8i-h3.dtsi
@@ -77,6 +77,14 @@
};
};

+ thermal-zones {
+ cpu_thermal: cpu_thermal {
+ polling-delay-passive = <1000>;
+ polling-delay = <5000>;
+ thermal-sensors = <&ths 0>;
+ };
+ };
+
timer {
compatible = "arm,armv7-timer";
interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
@@ -236,6 +244,14 @@
"ahb1_ephy", "ahb1_dbg";
};

+ ths_clk: clk@01c20074 {
+ #clock-cells = <0>;
+ compatible = "allwinner,sun8i-h3-ths-clk";
+ reg = <0x01c20074 0x4>;
+ clocks = <&osc24M>;
+ clock-output-names = "ths";
+ };
+
mmc0_clk: clk@01c20088 {
#clock-cells = <1>;
compatible = "allwinner,sun4i-a10-mmc-clk";
@@ -364,6 +380,10 @@
reg = <0x01c14000 0x400>;
#address-cells = <1>;
#size-cells = <1>;
+
+ ths_calibration: calib@234 {
+ reg = <0x234 0x4>;
+ };
};

usbphy: phy@01c19400 {
@@ -529,6 +549,19 @@
interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>;
};

+ ths: ths@01c25000 {
+ #thermal-sensor-cells = <0>;
+ compatible = "allwinner,sun8i-h3-ths";
+ reg = <0x01c25000 0x88>;
+ interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>;
+ resets = <&bus_rst 104>;
+ reset-names = "ahb";
+ clocks = <&bus_gates 72>, <&ths_clk>;
+ clock-names = "ahb", "ths";
+ nvmem-cells = <&ths_calibration>;
+ nvmem-cell-names = "calibration";
+ };
+
uart0: serial@01c28000 {
compatible = "snps,dw-apb-uart";
reg = <0x01c28000 0x400>;
--
2.4.10