From mboxrd@z Thu Jan 1 00:00:00 1970 From: Rob Herring Subject: Re: [PATCH 2/4 v2] drm: Add DT bindings documentation for ARC PGU display controller Date: Fri, 4 Mar 2016 22:30:01 -0600 Message-ID: <20160305043001.GB13525@rob-hp-laptop> References: <1457015956-30708-1-git-send-email-abrodkin@synopsys.com> <1457015956-30708-3-git-send-email-abrodkin@synopsys.com> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Return-path: Content-Disposition: inline In-Reply-To: <1457015956-30708-3-git-send-email-abrodkin@synopsys.com> Sender: linux-kernel-owner@vger.kernel.org To: Alexey Brodkin Cc: linux-kernel@vger.kernel.org, linux-snps-arc@lists.infradead.org, Pawel Moll , Mark Rutland , Ian Campbell , Kumar Gala , devicetree@vger.kernel.org List-Id: devicetree@vger.kernel.org On Thu, Mar 03, 2016 at 05:39:14PM +0300, Alexey Brodkin wrote: > This add DT bindings documentation for ARC PGU display controller. > > Signed-off-by: Alexey Brodkin > Cc: Rob Herring > Cc: Pawel Moll > Cc: Mark Rutland > Cc: Ian Campbell > Cc: Kumar Gala > Cc: devicetree@vger.kernel.org > Cc: linux-snps-arc@lists.infradead.org > --- > > Changes v1 -> v2: > * Clean-up Not really useful. What we like to see is what changed. Maintainers have short memories and don't remember what they said previously (unless comments are ignored). > > .../devicetree/bindings/display/snps,arcpgu.txt | 33 ++++++++++++++++++++++ > 1 file changed, 33 insertions(+) > create mode 100644 Documentation/devicetree/bindings/display/snps,arcpgu.txt > > diff --git a/Documentation/devicetree/bindings/display/snps,arcpgu.txt b/Documentation/devicetree/bindings/display/snps,arcpgu.txt > new file mode 100644 > index 0000000..57f3bc8 > --- /dev/null > +++ b/Documentation/devicetree/bindings/display/snps,arcpgu.txt > @@ -0,0 +1,33 @@ > +ARC PGU > + > +This is a display controller found on several development boards produced > +by Synopsys. The ARC PGU is an RGB streamer that reads the data from a > +framebuffer and sends it to a single digital encoder (usually HDMI). > + > +Required properties: > + - compatible: "snps,arcpgu" > + - reg: Physical base address and length of the controller's registers. > + - clocks: A list of phandle + clock-specifier pairs, one for each > + entry in 'clock-names'. > + - clock-names: A list of clock names. For ARC PGU it should contain: > + - "pxlclk" for the clock feeding the output PLL of the controller. > + > +Required sub-nodes: > + - port: The PGU connection to an encoder chip. The connection is modelled > + using the OF graph bindings specified in > + Documentation/devicetree/bindings/graph.txt. > + > +Example: > + > +/ { > + ... > + > + pgu@XXXXXXXX { > + compatible = "snps,arcpgu"; > + reg = <0xXXXXXXXX 0x400>; > + clocks = <&clock_node>; > + clock-names = "pxlclk"; Where's the port? Didn't you previously say it was optional? > + }; > + > + ... > +}; > -- > 2.5.0 >