[PATCH 12/41] Documentation: dt: input: fix spelling mistakes

Eric Engestrom
2016-04-25T00:24:09Z

Signed-off-by: Eric Engestrom <eric@engestrom.ch>
---
Documentation/devicetree/bindings/input/ads7846.txt | 2 +-
Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/input/ads7846.txt b/Documentation/devicetree/bindings/input/ads7846.txt
index c6cfe2e..9fc47b0 100644
--- a/Documentation/devicetree/bindings/input/ads7846.txt
+++ b/Documentation/devicetree/bindings/input/ads7846.txt
@@ -29,7 +29,7 @@ Optional properties:
ti,vref-delay-usecs vref supply delay in usecs, 0 for
external vref (u16).
ti,vref-mv The VREF voltage, in millivolts (u16).
- Set to 0 to use internal refernce
+ Set to 0 to use internal references
(ADS7846).
ti,keep-vref-on set to keep vref on for differential
measurements as well
diff --git a/Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt b/Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt
index cdf05f9..abfcab3 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt
@@ -15,7 +15,7 @@ Optional properties:
- fsl,pen-debounce-ns: Pen debounce time in nanoseconds.
- fsl,pen-threshold: Pen-down threshold for the touchscreen. This is a value
between 1 and 4096. It is the ratio between the internal reference voltage
- and the measured voltage after the plate was precharged. Resistence between
+ and the measured voltage after the plate was precharged. Resistance between
plates and therefore the voltage decreases with pressure so that a smaller
value is equivalent to a higher pressure.
- fsl,settling-time-ns: Settling time in nanoseconds. The settling time is before
--
2.8.0