From mboxrd@z Thu Jan 1 00:00:00 1970 From: Karl Beldan Subject: [PATCH 2/4] ARM: dts: da850: Add an aemif node Date: Tue, 9 Aug 2016 17:15:16 +0000 Message-ID: <20160809171518.22690-3-kbeldan@baylibre.com> References: <20160809171518.22690-1-kbeldan@baylibre.com> Return-path: In-Reply-To: <20160809171518.22690-1-kbeldan@baylibre.com> Sender: linux-kernel-owner@vger.kernel.org To: devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org Cc: linux-kernel@vger.kernel.org, Rob Herring , Mark Rutland , Russell King , Santosh Shilimkar , Sekhar Nori , Kevin Hilman , Karl Beldan , Karl Beldan List-Id: devicetree@vger.kernel.org Currently the davinci da8xx boards use the mach-davinci aemif code. Instantiating an aemif node into the DT allows to use the ti-aemif memory driver and is another step to better DT support. Also it will allow to properly pass the emif timings via DT. Signed-off-by: Karl Beldan --- arch/arm/boot/dts/da850.dtsi | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi index bc10e7e..f62928c 100644 --- a/arch/arm/boot/dts/da850.dtsi +++ b/arch/arm/boot/dts/da850.dtsi @@ -411,6 +411,16 @@ dma-names = "tx", "rx"; }; }; + aemif: aemif@68000000 { + compatible = "ti,da850-aemif"; + #address-cells = <2>; + #size-cells = <1>; + + reg = <0x68000000 0x00008000>; + ranges = <0 0 0x60000000 0x08000000 + 1 0 0x68000000 0x00008000>; + status = "disabled"; + }; nand_cs3@62000000 { compatible = "ti,davinci-nand"; reg = <0x62000000 0x807ff -- 2.9.2