Re: [PATCH 02/13] Documentation: add BCM6328 pincontroller binding documentation

[Rob Herring <robh@kernel.org>]

On Fri, Aug 19, 2016 at 12:53:34PM +0200, Jonas Gorski wrote:
> Add binding documentation for the pincontrol core found in BCM6328 SoCs.
> 
> Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
> ---
>  .../bindings/pinctrl/brcm,bcm6328-pinctrl.txt      | 61 ++++++++++++++++++++++
>  1 file changed, 61 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/pinctrl/brcm,bcm6328-pinctrl.txt
> 
> diff --git a/Documentation/devicetree/bindings/pinctrl/brcm,bcm6328-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/brcm,bcm6328-pinctrl.txt
> new file mode 100644
> index 0000000..401224e
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/pinctrl/brcm,bcm6328-pinctrl.txt
> @@ -0,0 +1,61 @@
> +* Broadcom BCM6328 pin controller
> +
> +Required properties:
> +- compatible: Must be "brcm,bcm6328-pinctrl".
> +- reg: Register specifies of dirout, dat, mode, mux registers.
> +- reg-names: Must be "dirout", "dat", "mode", "mux".
> +- gpio-controller: Identifies this node as a GPIO controller.
> +- #gpio-cells: Must be <2>.
> +
> +Example:
> +
> +pinctrl: pin-controller@10000080 {
> +	compatible = "brcm,bcm6328-pinctrl";
> +	reg = <0x10000080 0x8>,
> +	      <0x10000088 0x8>,
> +	      <0x10000098 0x4>,
> +	      <0x1000009c 0xc>;
> +	reg-names = "dirout", "dat", "mode", "mux";

What's in the holes? Just do one range or perhaps this should be part of 
some larger block.

Rob