From: Krzysztof Kozlowski <krzk-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
To: Chanwoo Choi <cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
Cc: krzk-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
javier-JPH+aEBZ4P+UEJcrhfAQsw@public.gmane.org,
kgene-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org,
s.nawrocki-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
tomasz.figa-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org,
myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
kyungmin.park-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-samsung-soc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Subject: Re: [PATCH 5/5] arm64: dts: exynos5433: Add support of bus frequency using VDD_INT on TM2
Date: Tue, 6 Dec 2016 21:24:50 +0200 [thread overview]
Message-ID: <20161206192450.GC12683@kozik-lap> (raw)
In-Reply-To: <1480663087-4590-6-git-send-email-cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
On Fri, Dec 02, 2016 at 04:18:07PM +0900, Chanwoo Choi wrote:
> This patch adds the bus Device-tree nodes for INT (Internal) block
> to enable the bus frequency scaling.
>
> Signed-off-by: Chanwoo Choi <cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
> ---
> arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 72 +++++++++++++++++++++++++++
> 1 file changed, 72 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> index c08589970134..7b37aae336b1 100644
> --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> @@ -170,6 +170,58 @@
> };
> };
>
> +&bus_g2d_400 {
> + devfreq-events = <&ppmu_event0_d0_general>, <&ppmu_event0_d1_general>;
> + vdd-supply = <&buck4_reg>;
> + exynos,saturation-ratio = <10>;
> + status = "okay";
> +};
> +
> +&bus_mscl {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_jpeg {
Except the first entry (which is a parent), are there any objections to
order these nodes alphabetically? This also applies to the previously
patch.
Beside that nit, looks good. I will have to wait anyway to next merge
window, so for the reference:
Reviewed-by: Krzysztof Kozlowski <krzk-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
Best regards,
Krzysztof
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_mfc {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_g2d_266 {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_gscl {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_hevc {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_bus0 {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_bus1 {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> +&bus_bus2 {
> + devfreq = <&bus_g2d_400>;
> + status = "okay";
> +};
> +
> &cmu_aud {
> assigned-clocks = <&cmu_aud CLK_MOUT_AUD_PLL_USER>;
> assigned-clock-parents = <&cmu_top CLK_FOUT_AUD_PLL>;
> @@ -794,6 +846,26 @@
> bus-width = <4>;
> };
>
> +&ppmu_d0_general {
> + status = "okay";
> +
> + events {
> + ppmu_event0_d0_general: ppmu-event0-d0-general {
> + event-name = "ppmu-event0-d0-general";
> + };
> + };
> +};
> +
> +&ppmu_d1_general {
> + status = "okay";
> +
> + events {
> + ppmu_event0_d1_general: ppmu-event0-d1-general {
> + event-name = "ppmu-event0-d1-general";
> + };
> + };
> +};
> +
> &pinctrl_alive {
> pinctrl-names = "default";
> pinctrl-0 = <&initial_alive>;
> --
> 1.9.1
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
prev parent reply other threads:[~2016-12-06 19:24 UTC|newest]
Thread overview: 13+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-12-02 7:18 [PATCH 0/5] arm64: dts: Enable bus frequency scaling on Exynos5433-based TM2 board Chanwoo Choi
2016-12-02 7:18 ` [PATCH 1/5] clk: samsung: exynos5433: Set NoC (Network On Chip) clocks as critical Chanwoo Choi
2016-12-02 7:18 ` [PATCH 2/5] PM / devfreq: exynos-bus: Add the detailed correlation for Exynos5433 Chanwoo Choi
[not found] ` <1480663087-4590-1-git-send-email-cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-02 7:18 ` [PATCH 3/5] arm64: dts: exynos5433: Add PPMU dt node Chanwoo Choi
[not found] ` <1480663087-4590-4-git-send-email-cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-06 19:07 ` Krzysztof Kozlowski
2016-12-07 4:12 ` Chanwoo Choi
[not found] ` <58478C41.5090500-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-07 5:54 ` Chanwoo Choi
[not found] ` <5847A419.9050801-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-07 6:13 ` Krzysztof Kozlowski
2016-12-02 7:18 ` [PATCH 4/5] arm64: dts: exynos5433: Add bus dt node using VDD_INT for Exynos5433 Chanwoo Choi
[not found] ` <1480663087-4590-5-git-send-email-cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-06 19:21 ` Krzysztof Kozlowski
2016-12-07 11:17 ` Chanwoo Choi
2016-12-02 7:18 ` [PATCH 5/5] arm64: dts: exynos5433: Add support of bus frequency using VDD_INT on TM2 Chanwoo Choi
[not found] ` <1480663087-4590-6-git-send-email-cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2016-12-06 19:24 ` Krzysztof Kozlowski [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20161206192450.GC12683@kozik-lap \
--to=krzk-dgejt+ai2ygdnm+yrofe0a@public.gmane.org \
--cc=cw00.choi-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=javier-JPH+aEBZ4P+UEJcrhfAQsw@public.gmane.org \
--cc=kgene-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=kyungmin.park-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-samsung-soc-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=myungjoo.ham-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=s.nawrocki-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org \
--cc=tomasz.figa-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).