* [PATCH] ARM: dts: Configure regulators for droid 4
@ 2017-02-04 20:17 Tony Lindgren
0 siblings, 0 replies; only message in thread
From: Tony Lindgren @ 2017-02-04 20:17 UTC (permalink / raw)
To: linux-omap-u79uwXL29TY76Z2rM5mHXA
Cc: linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r,
devicetree-u79uwXL29TY76Z2rM5mHXA, Marcel Partap, Michael Scott
With drivers/mfd/motorola-cpcap.c and drivers/regulator/cpcap-regulator.c
we can now configure proper regulators for droid 4.
Let's add regulator voltages and switch over MMC, eMMC and WLAN to use
the CPCAP regulators.
Cc: devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Cc: Marcel Partap <mpartap-hi6Y0CQ0nG0@public.gmane.org>
Cc: Michael Scott <michael.scott-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>
Signed-off-by: Tony Lindgren <tony-4v6yS6AI5VpBDgjK7y7TUQ@public.gmane.org>
---
arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi | 151 +++++++++++++++++++++++++
arch/arm/boot/dts/omap4-droid4-xt894.dts | 25 +---
2 files changed, 155 insertions(+), 21 deletions(-)
create mode 100644 arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
diff --git a/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi b/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
new file mode 100644
--- /dev/null
+++ b/arch/arm/boot/dts/motorola-cpcap-mapphone.dtsi
@@ -0,0 +1,151 @@
+/*
+ * Common CPCAP configuration used on Motorola phones
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+&mcspi1 {
+ cpcap: pmic@0 {
+ compatible = "motorola,cpcap", "st,6556002";
+ reg = <0>; /* cs0 */
+ interrupt-parent = <&gpio1>;
+ interrupts = <7 IRQ_TYPE_EDGE_RISING>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ spi-max-frequency = <3000000>;
+ spi-cs-high;
+
+ cpcap_regulator: regulator {
+ compatible = "motorola,mapphone-cpcap-regulator";
+
+ cpcap_regulators: regulators {
+ };
+ };
+ };
+};
+
+&cpcap_regulators {
+ sw5: SW5 {
+ regulator-min-microvolt = <5050000>;
+ regulator-max-microvolt = <5050000>;
+ regulator-enable-ramp-delay = <50000>;
+ regulator-boot-on;
+ };
+
+ vcam: VCAM {
+ regulator-min-microvolt = <2900000>;
+ regulator-max-microvolt = <2900000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ /* Used by DSS */
+ vcsi: VCSI {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-enable-ramp-delay = <1000>;
+ regulator-boot-on;
+ };
+
+ vdac: VDAC {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vdig: VDIG {
+ regulator-min-microvolt = <1875000>;
+ regulator-max-microvolt = <1875000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vfuse: VFUSE {
+ regulator-min-microvolt = <1500000>;
+ regulator-max-microvolt = <3150000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vhvio: VHVIO {
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-enable-ramp-delay = <1000>;
+ regulator-always-on;
+ };
+
+ /* Used by eMMC at mmc2 */
+ vsdio: VSDIO {
+ regulator-min-microvolt = <2900000>;
+ regulator-max-microvolt = <2900000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vpll: VPLL {
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-enable-ramp-delay = <100>;
+ };
+
+ vrf1: VRF1 {
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vrf2: VRF2 {
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vrfref: VRFREF {
+ regulator-min-microvolt = <2500000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-enable-ramp-delay = <100>;
+ };
+
+ vwlan1: VWLAN1 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1900000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vwlan2: VWLAN2 {
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3000000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vsim: VSIM {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2900000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ /* Used by micro-SDIO at mmc1 */
+ vsimcard: VSIMCARD {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2900000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vvib: VVIB {
+ regulator-min-microvolt = <1300000>;
+ regulator-max-microvolt = <3000000>;
+ regulator-enable-ramp-delay = <500>;
+ };
+
+ vusb: VUSB {
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+
+ vaudio: VAUDIO {
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+};
diff --git a/arch/arm/boot/dts/omap4-droid4-xt894.dts b/arch/arm/boot/dts/omap4-droid4-xt894.dts
--- a/arch/arm/boot/dts/omap4-droid4-xt894.dts
+++ b/arch/arm/boot/dts/omap4-droid4-xt894.dts
@@ -7,6 +7,7 @@
#include <dt-bindings/input/input.h>
#include "omap443x.dtsi"
+#include "motorola-cpcap-mapphone.dtsi"
/ {
model = "Motorola Droid 4 XT894";
@@ -26,25 +27,7 @@
reg = <0x80000000 0x3fd00000>; /* 1021 MB */
};
- /* CPCAP really supports 1650000 to 3400000 range */
- vmmc: regulator-mmc {
- compatible = "regulator-fixed";
- regulator-name = "vmmc";
- regulator-min-microvolt = <3000000>;
- regulator-max-microvolt = <3000000>;
- regulator-always-on;
- };
-
- /* CPCAP really supports 3000000 to 3100000 range */
- vemmc: regulator-emmc {
- compatible = "regulator-fixed";
- regulator-name = "vemmc";
- regulator-min-microvolt = <3000000>;
- regulator-max-microvolt = <3000000>;
- regulator-always-on;
- };
-
- /* CPCAP really supports 1650000 to 1950000 range */
+ /* This is probably coming straight from the battery.. */
wl12xx_vmmc: regulator-wl12xx {
compatible = "regulator-fixed";
regulator-name = "vwl1271";
@@ -136,13 +119,13 @@
};
&mmc1 {
- vmmc-supply = <&vmmc>;
+ vmmc-supply = <&vsimcard>;
bus-width = <4>;
cd-gpios = <&gpio4 10 GPIO_ACTIVE_LOW>; /* gpio106 */
};
&mmc2 {
- vmmc-supply = <&vemmc>;
+ vmmc-supply = <&vsdio>;
bus-width = <8>;
non-removable;
};
--
2.11.0
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2017-02-04 20:17 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2017-02-04 20:17 [PATCH] ARM: dts: Configure regulators for droid 4 Tony Lindgren
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).