[PATCH v3 08/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Banana Pi M2+

Corentin Labbe
2017-04-03T09:14:32Z

From: LABBE Corentin <clabbe.montjoie@gmail.com>

The dwmac-sun8i hardware is present on the Banana Pi M2+
It uses an external PHY rtl8211e via RGMII.

This patch create the needed regulator, emac and phy nodes.

Signed-off-by: Corentin Labbe <clabbe.montjoie@gmail.com>
---
arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 38 +++++++++++++++++++++++++
1 file changed, 38 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index 52acbe1..7fd7704 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
@@ -90,6 +90,18 @@
pinctrl-0 = <&wifi_en_bpi_m2p>;
reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
};
+
+ reg_gmac_3v3: gmac-3v3 {
+ compatible = "regulator-fixed";
+ pinctrl-names = "default";
+ pinctrl-0 = <&gmac_power_pin_orangepi>;
+ regulator-name = "gmac-3v3";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ startup-delay-us = <100000>;
+ enable-active-high;
+ gpio = <&pio 3 6 GPIO_ACTIVE_HIGH>;
+ };
};

&ehci1 {
@@ -186,3 +198,29 @@
/* USB VBUS is on as long as VCC-IO is on */
status = "okay";
};
+
+&pio {
+ gmac_power_pin_orangepi: gmac_power_pin@0 {
+ pins = "PD6";
+ function = "gpio_out";
+ drive-strength = <10>;
+ };
+};
+
+&mdio {
+ ext_rgmii_phy: ethernet-phy@1 {
+ compatible = "ethernet-phy-ieee802.3-c22";
+ reg = <0>;
+ };
+};
+
+&emac {
+ pinctrl-names = "default";
+ pinctrl-0 = <&emac_rgmii_pins>;
+ phy-supply = <&reg_gmac_3v3>;
+ phy-handle = <&ext_rgmii_phy>;
+ phy-mode = "rgmii";
+
+ allwinner,leds-active-low;
+ status = "okay";
+};
--
2.10.2