Re: [PATCH V2 1/4] dt-bindings: pci: tegra: Document Tegra186 PCIe DT

[Thierry Reding <thierry.reding-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>]

[-- Attachment #1: Type: text/plain, Size: 6434 bytes --]

On Wed, Sep 27, 2017 at 05:28:34PM +0530, Manikanta Maddireddy wrote:
> Tegra186 PCIe controller DT properties has couple of differences
> wrt Tegra210 PCIe, rest of the DT properties are same.
> 
> Signed-off-by: Manikanta Maddireddy <mmaddireddy-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
> Reviewed-by: Mikko Perttunen <mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
> Tested-by: Mikko Perttunen <mperttunen-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
> ---
> V2: No change in this patch
>  .../bindings/pci/nvidia,tegra20-pcie.txt           | 134 ++++++++++++++++++++-
>  1 file changed, 130 insertions(+), 4 deletions(-)

Hi Rob,

Manikanta forgot to add you on Cc on this one. Can you take a look or
should Manikanta resend the series to include you and the device tree
mailing list?

FWIW, this looks good to me, so:

Acked-by: Thierry Reding <treding-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>

Bjorn,

I take it that you'd pull this into the PCI tree along with the host
controller driver changes? I can take patches 3 and 4 through the Tegra
tree.

Thierry

> diff --git a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
> index 982a74ea6df9..753b67327373 100644
> --- a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
> +++ b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
> @@ -1,10 +1,15 @@
>  NVIDIA Tegra PCIe controller
>  
>  Required properties:
> -- compatible: For Tegra20, must contain "nvidia,tegra20-pcie".  For Tegra30,
> -  "nvidia,tegra30-pcie".  For Tegra124, must contain "nvidia,tegra124-pcie".
> -  Otherwise, must contain "nvidia,<chip>-pcie", plus one of the above, where
> -  <chip> is tegra132 or tegra210.
> +- compatible: Must be:
> +  - "nvidia,tegra20-pcie": for Tegra20
> +  - "nvidia,tegra30-pcie": for Tegra30
> +  - "nvidia,tegra124-pcie": for Tegra124 and Tegra132
> +  - "nvidia,tegra210-pcie": for Tegra210
> +  - "nvidia,tegra186-pcie": for Tegra186
> +- power-domains: To ungate power partition by BPMP powergate driver. Must
> +contain BPMP phandle and PCIe power partition ID. This is required only
> +for Tegra186.
>  - device_type: Must be "pci"
>  - reg: A list of physical base address and length for each set of controller
>    registers. Must contain an entry for each entry in the reg-names property.
> @@ -124,6 +129,16 @@ Power supplies for Tegra210:
>    - vddio-pex-ctl-supply: Power supply for PCIe control I/O partition. Must
>      supply 1.8 V.
>  
> +Power supplies for Tegra186:
> +- Required:
> +  - dvdd-pex-supply: Power supply for digital PCIe I/O. Must supply 1.05 V.
> +  - hvdd-pex-pll-supply: High-voltage supply for PLLE (shared with USB3). Must
> +    supply 1.8 V.
> +  - hvdd-pex-supply: High-voltage supply for PCIe I/O and PCIe output clocks.
> +    Must supply 1.8 V.
> +  - vddio-pexctl-aud-supply: Power supply for PCIe side band signals. Must
> +    supply 1.8 V.
> +
>  Root ports are defined as subnodes of the PCIe controller node.
>  
>  Required properties:
> @@ -546,3 +561,114 @@ Board DTS:
>  			status = "okay";
>  		};
>  	};
> +
> +Tegra186:
> +---------
> +
> +SoC DTSI:
> +
> +	pcie@10003000 {
> +		compatible = "nvidia,tegra186-pcie";
> +		power-domains = <&bpmp TEGRA186_POWER_DOMAIN_PCX>;
> +		device_type = "pci";
> +		reg = <0x0 0x10003000 0x0 0x00000800   /* PADS registers */
> +		       0x0 0x10003800 0x0 0x00000800   /* AFI registers */
> +		       0x0 0x40000000 0x0 0x10000000>; /* configuration space */
> +		reg-names = "pads", "afi", "cs";
> +
> +		interrupts = <GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>, /* controller interrupt */
> +			     <GIC_SPI 73 IRQ_TYPE_LEVEL_HIGH>; /* MSI interrupt */
> +		interrupt-names = "intr", "msi";
> +
> +		#interrupt-cells = <1>;
> +		interrupt-map-mask = <0 0 0 0>;
> +		interrupt-map = <0 0 0 0 &gic GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>;
> +
> +		bus-range = <0x00 0xff>;
> +		#address-cells = <3>;
> +		#size-cells = <2>;
> +
> +		ranges = <0x82000000 0 0x10000000 0x0 0x10000000 0 0x00001000   /* port 0 configuration space */
> +			  0x82000000 0 0x10001000 0x0 0x10001000 0 0x00001000   /* port 1 configuration space */
> +			  0x82000000 0 0x10004000 0x0 0x10004000 0 0x00001000   /* port 2 configuration space */
> +			  0x81000000 0 0x0        0x0 0x50000000 0 0x00010000   /* downstream I/O (64 KiB) */
> +			  0x82000000 0 0x50100000 0x0 0x50100000 0 0x07F00000   /* non-prefetchable memory (127 MiB) */
> +			  0xc2000000 0 0x58000000 0x0 0x58000000 0 0x28000000>; /* prefetchable memory (640 MiB) */
> +
> +		clocks = <&bpmp TEGRA186_CLK_AFI>,
> +			 <&bpmp TEGRA186_CLK_PCIE>,
> +			 <&bpmp TEGRA186_CLK_PLLE>;
> +		clock-names = "afi", "pex", "pll_e";
> +
> +		resets = <&bpmp TEGRA186_RESET_AFI>,
> +			 <&bpmp TEGRA186_RESET_PCIE>,
> +			 <&bpmp TEGRA186_RESET_PCIEXCLK>;
> +		reset-names = "afi", "pex", "pcie_x";
> +
> +		status = "disabled";
> +
> +		pci@1,0 {
> +			device_type = "pci";
> +			assigned-addresses = <0x82000800 0 0x10000000 0 0x1000>;
> +			reg = <0x000800 0 0 0 0>;
> +			status = "disabled";
> +
> +			#address-cells = <3>;
> +			#size-cells = <2>;
> +			ranges;
> +
> +			nvidia,num-lanes = <2>;
> +		};
> +
> +		pci@2,0 {
> +			device_type = "pci";
> +			assigned-addresses = <0x82001000 0 0x10001000 0 0x1000>;
> +			reg = <0x001000 0 0 0 0>;
> +			status = "disabled";
> +
> +			#address-cells = <3>;
> +			#size-cells = <2>;
> +			ranges;
> +
> +			nvidia,num-lanes = <1>;
> +		};
> +
> +		pci@3,0 {
> +			device_type = "pci";
> +			assigned-addresses = <0x82001800 0 0x10004000 0 0x1000>;
> +			reg = <0x001800 0 0 0 0>;
> +			status = "disabled";
> +
> +			#address-cells = <3>;
> +			#size-cells = <2>;
> +			ranges;
> +
> +			nvidia,num-lanes = <1>;
> +		};
> +	};
> +
> +Board DTS:
> +
> +	pcie@10003000 {
> +		status = "okay";
> +
> +		dvdd-pex-supply = <&vdd_pex>;
> +		hvdd-pex-pll-supply = <&vdd_1v8>;
> +		hvdd-pex-supply = <&vdd_1v8>;
> +		vddio-pexctl-aud-supply = <&vdd_1v8>;
> +
> +		pci@1,0 {
> +			nvidia,num-lanes = <4>;
> +			status = "okay";
> +		};
> +
> +		pci@2,0 {
> +			nvidia,num-lanes = <0>;
> +			status = "disabled";
> +		};
> +
> +		pci@3,0 {
> +			nvidia,num-lanes = <1>;
> +			status = "disabled";
> +		};
> +	};
> -- 
> 2.1.4
> 

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 833 bytes --]