Re: [PATCH 3/3] Documentation: add Actions S900 clock bindings

[Rob Herring <robh@kernel.org>]

On Wed, Nov 01, 2017 at 01:24:23AM +0530, Manivannan Sadhasivam wrote:
> This patch adds clock bindings for Actions Semi S900 SoC.

"dt-bindings: clock: " for the subject.

This patch should come before the dts and driver changes.

> 
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
> ---
>  .../bindings/clock/actions,s900-clock.txt          | 47 ++++++++++++++++++++++
>  1 file changed, 47 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/clock/actions,s900-clock.txt
> 
> diff --git a/Documentation/devicetree/bindings/clock/actions,s900-clock.txt b/Documentation/devicetree/bindings/clock/actions,s900-clock.txt
> new file mode 100644
> index 0000000..951d6ad
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/clock/actions,s900-clock.txt
> @@ -0,0 +1,47 @@
> +* Actions s900 Clock Controller
> +
> +The Actions s900 clock controller generates and supplies clock to various
> +controllers within the SoC. The clock binding described here is applicable to
> +s900 SoC.
> +
> +Required Properties:
> +
> +- compatible: should be "actions,s900-clock"
> +- reg: physical base address of the controller and length of memory mapped
> +  region.
> +- #clock-cells: should be 1.
> +
> +Each clock is assigned an identifier and client nodes can use this identifier
> +to specify the clock which they consume.
> +
> +All available clocks are defined as preprocessor macros in
> +dt-bindings/clock/actions,s900-clock.h header and can be used in device
> +tree sources.
> +
> +External clocks:
> +
> +The hosc clock used as input for the plls is generated outside the SoC. It is
> +expected that it is defined using standard clock bindings as "hosc".
> +
> +Actions s900 Clock Controller also require two more clocks:
> + - "losc" - internal low frequency oscillator
> + - "diff_24M" - internal differential 24MHz clock
> +
> +Example: Clock controller node:
> +
> +        clock: clock-controller@e0160000 {
> +		compatible = "actions,s900-clock";
> +		reg = <0 0xe0160000 0 0x1000>;
> +		#clock-cells = <1>;
> +	};
> +
> +Example: UART controller node that consumes clock generated by the clock
> +controller:
> +
> +	serial5: uart@e012a000 {

serial@...

> +		compatible = "actions,s900-uart", "actions,owl-uart";
> +		reg = <0x0 0xe012a000 0x0 0x2000>;
> +		interrupts = <GIC_SPI 34 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&clock CLK_UART5>;
> +		clock-names = "uart";
> +	};
> -- 
> 2.7.4
>