[PATCH 4/7] dt-bindings: display: msm/dsi: Remove unused properties

[Archit Taneja <architt@codeaurora.org>]

"qcom,dsi-host-index" and "qcom,dsi-phy-index" DT props aren't
acceptable and have never been used in any DT files. Remove them.

Cc: Rob Herring <robh@kernel.org>
Cc: devicetree@vger.kernel.org
Signed-off-by: Archit Taneja <architt@codeaurora.org>
---
 Documentation/devicetree/bindings/display/msm/dsi.txt | 4 ----
 1 file changed, 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/display/msm/dsi.txt b/Documentation/devicetree/bindings/display/msm/dsi.txt
index a6671bd2c85a..457c688736be 100644
--- a/Documentation/devicetree/bindings/display/msm/dsi.txt
+++ b/Documentation/devicetree/bindings/display/msm/dsi.txt
@@ -7,8 +7,6 @@ Required properties:
 - reg: Physical base address and length of the registers of controller
 - reg-names: The names of register regions. The following regions are required:
   * "dsi_ctrl"
-- qcom,dsi-host-index: The ID of DSI controller hardware instance. This should
-  be 0 or 1, since we have 2 DSI controllers at most for now.
 - interrupts: The interrupt signal from the DSI block.
 - power-domains: Should be <&mmcc MDSS_GDSC>.
 - clocks: Phandles to device clocks.
@@ -96,8 +94,6 @@ Required properties:
   * "dsi_phy_regulator"
 - clock-cells: Must be 1. The DSI PHY block acts as a clock provider, creating
   2 clocks: A byte clock (index 0), and a pixel clock (index 1).
-- qcom,dsi-phy-index: The ID of DSI PHY hardware instance. This should
-  be 0 or 1, since we have 2 DSI PHYs at most for now.
 - power-domains: Should be <&mmcc MDSS_GDSC>.
 - clocks: Phandles to device clocks. See [1] for details on clock bindings.
 - clock-names: the following clocks are required:
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation

_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel