From: Boris Brezillon <boris.brezillon@bootlin.com>
To: Stefan Agner <stefan@agner.ch>
Cc: dwmw2@infradead.org, computersforpeace@gmail.com,
marek.vasut@gmail.com, robh+dt@kernel.org, mark.rutland@arm.com,
thierry.reding@gmail.com, mturquette@baylibre.com,
sboyd@kernel.org, dev@lynxeye.de, miquel.raynal@bootlin.com,
richard@nod.at, marcel@ziswiler.com, krzk@kernel.org,
digetx@gmail.com, benjamin.lindqvist@endian.se,
jonathanh@nvidia.com, pdeschrijver@nvidia.com,
pgaikwad@nvidia.com, mirza.krak@gmail.com,
linux-mtd@lists.infradead.org, linux-tegra@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-clk@vger.kernel.org
Subject: Re: [RESEND PATCH 1/5] mtd: rawnand: tegra: add devicetree binding
Date: Tue, 22 May 2018 19:52:30 +0200 [thread overview]
Message-ID: <20180522195230.471a796e@bbrezillon> (raw)
In-Reply-To: <8bd0f80a9db9abc7af192d1c7d449887b1392ff7.1526990589.git.stefan@agner.ch>
Hello Stefan,
On Tue, 22 May 2018 14:07:05 +0200
Stefan Agner <stefan@agner.ch> wrote:
> From: Lucas Stach <dev@lynxeye.de>
>
> This adds the devicetree binding for the Tegra 2 NAND flash
> controller.
>
> Signed-off-by: Lucas Stach <dev@lynxeye.de>
> Signed-off-by: Stefan Agner <stefan@agner.ch>
> ---
> .../bindings/mtd/nvidia,tegra20-nand.txt | 29 +++++++++++++++++++
> 1 file changed, 29 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/nvidia,tegra20-nand.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/nvidia,tegra20-nand.txt b/Documentation/devicetree/bindings/mtd/nvidia,tegra20-nand.txt
> new file mode 100644
> index 000000000000..522d442937a9
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/nvidia,tegra20-nand.txt
> @@ -0,0 +1,29 @@
> +NVIDIA Tegra NAND Flash controller
> +
> +Required properties:
> +- compatible: Must be one of:
> + - "nvidia,tegra20-nand"
> +- reg: MMIO address range
> +- interrupts: interrupt output of the NFC controller
> +- clocks: Must contain an entry for each entry in clock-names.
> + See ../clocks/clock-bindings.txt for details.
> +- clock-names: Must include the following entries:
> + - nand
> +- resets: Must contain an entry for each entry in reset-names.
> + See ../reset/reset.txt for details.
> +- reset-names: Must include the following entries:
> + - nand
> +
> +Optional properties:
> +- nvidia,wp-gpios: GPIO used to disable write protection of the flash
> +
> + Example:
> + nand@70008000 {
> + compatible = "nvidia,tegra20-nand";
> + reg = <0x70008000 0x100>;
> + interrupts = <GIC_SPI 24 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&tegra_car TEGRA20_CLK_NDFLASH>;
> + clock-names = "nand";
> + resets = <&tegra_car 13>;
> + reset-names = "nand";
> + };
Can you represent the controller and NAND chip separately as
recommended here [1].
Thanks,
Boris
[1]https://elixir.bootlin.com/linux/v4.17-rc6/source/Documentation/devicetree/bindings/mtd/nand.txt#L56
next prev parent reply other threads:[~2018-05-22 17:52 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-05-22 12:07 [RESEND PATCH 0/5] mtd: rawnand: add NVIDIA Tegra NAND flash support Stefan Agner
2018-05-22 12:07 ` [RESEND PATCH 1/5] mtd: rawnand: tegra: add devicetree binding Stefan Agner
2018-05-22 17:52 ` Boris Brezillon [this message]
2018-05-22 12:07 ` [RESEND PATCH 2/5] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver Stefan Agner
2018-05-22 12:16 ` Dmitry Osipenko
2018-05-22 12:19 ` Stefan Agner
2018-05-22 13:34 ` Dmitry Osipenko
2018-05-22 14:28 ` Stefan Agner
2018-05-22 14:53 ` Stefan Agner
2018-05-22 17:55 ` Boris Brezillon
2018-05-23 14:18 ` Boris Brezillon
2018-05-24 8:46 ` Stefan Agner
2018-05-24 8:56 ` Boris Brezillon
2018-05-24 11:09 ` Stefan Agner
2018-05-24 12:23 ` Boris Brezillon
2018-05-24 12:41 ` Boris Brezillon
2018-05-24 22:56 ` Stefan Agner
2018-05-24 12:27 ` Boris Brezillon
2018-05-24 7:40 ` Benjamin Lindqvist
2018-05-24 7:45 ` Benjamin Lindqvist
2018-05-24 11:00 ` Stefan Agner
2018-05-24 11:07 ` Boris Brezillon
2018-05-24 11:30 ` Benjamin Lindqvist
2018-05-24 11:53 ` Boris Brezillon
2018-05-24 12:19 ` Stefan Agner
2018-05-27 22:04 ` Miquel Raynal
2018-05-28 12:39 ` Stefan Agner
2018-05-31 17:54 ` Stefan Agner
2018-05-31 20:30 ` Boris Brezillon
2018-05-31 21:44 ` Stefan Agner
2018-05-22 12:07 ` [RESEND PATCH 3/5] clk: tegra20: init NDFLASH clock to sensible rate Stefan Agner
2018-05-22 12:07 ` [RESEND PATCH 4/5] ARM: tegra: add Tegra20 NAND flash controller node Stefan Agner
2018-05-22 12:07 ` [RESEND PATCH 5/5] ARM: tegra: enable NAND flash on Colibri T20 Stefan Agner
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180522195230.471a796e@bbrezillon \
--to=boris.brezillon@bootlin.com \
--cc=benjamin.lindqvist@endian.se \
--cc=computersforpeace@gmail.com \
--cc=dev@lynxeye.de \
--cc=devicetree@vger.kernel.org \
--cc=digetx@gmail.com \
--cc=dwmw2@infradead.org \
--cc=jonathanh@nvidia.com \
--cc=krzk@kernel.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-tegra@vger.kernel.org \
--cc=marcel@ziswiler.com \
--cc=marek.vasut@gmail.com \
--cc=mark.rutland@arm.com \
--cc=miquel.raynal@bootlin.com \
--cc=mirza.krak@gmail.com \
--cc=mturquette@baylibre.com \
--cc=pdeschrijver@nvidia.com \
--cc=pgaikwad@nvidia.com \
--cc=richard@nod.at \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=stefan@agner.ch \
--cc=thierry.reding@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).