From mboxrd@z Thu Jan 1 00:00:00 1970 From: Florian Fainelli Subject: [PATCH 0/9] AHCI and SATA PHY support for BCM63138 Date: Thu, 20 Sep 2018 12:16:34 -0700 Message-ID: <20180920191646.18198-1-f.fainelli@gmail.com> Return-path: Sender: linux-kernel-owner@vger.kernel.org To: linux-kernel@vger.kernel.org Cc: Florian Fainelli , Jens Axboe , Rob Herring , Mark Rutland , Kishon Vijay Abraham I , Al Cooper , Ray Jui , Tejun Heo , Fengguang Wu , Arnd Bergmann , "open list:LIBATA SUBSYSTEM Serial and Parallel ATA drivers" , "open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS" , bcm-kernel-feedback-list@broadcom.com List-Id: devicetree@vger.kernel.org Hi Kishon, Tejun, This patch series adds support for the SATA AHCI and PHY found on the ARM-basd BCM63138 DSL SoCs. It would probably make sense for patches 1-3 to go through Kishon's tree, patches 4-7 through Tejun's tree, and I would be merging the last two patches through the Broadcom ARM-SoC tree. Let me know if this is not a workable plan, thank you very much! Florian Fainelli (9): dt-bindings: phy: Document BCM63138 compatible string phy: brcm-sata: allow PHY_BRCM_SATA driver to be built for DSL SoCs phy: brcm-sata: Add BCM63138 (DSL) PHY init sequence dt-bindings: ata: Document BCM63138 compatible string ata: ahci_brcm: Allow optional reset controller to be used ata: ahci_brcm: Match BCM63138 compatible strings ata: ahci_brcm: Allow using driver or DSL SoCs ARM: dts: BCM63xx: enable SATA PHY and AHCI controller ARM: bcm63138: Enable SATA AHCI and PHY .../bindings/ata/brcm,sata-brcm.txt | 1 + .../devicetree/bindings/phy/brcm-sata-phy.txt | 1 + arch/arm/boot/dts/bcm63138.dtsi | 30 ++++++++ arch/arm/boot/dts/bcm963138dvt.dts | 8 +++ drivers/ata/Kconfig | 3 +- drivers/ata/ahci_brcm.c | 10 +++ drivers/phy/broadcom/Kconfig | 3 +- drivers/phy/broadcom/phy-brcm-sata.c | 70 +++++++++++++++++++ 8 files changed, 124 insertions(+), 2 deletions(-) -- 2.17.1