From mboxrd@z Thu Jan 1 00:00:00 1970 From: Joseph Lo Subject: [PATCH 01/19] dt-bindings: clock: tegra124-dfll: Update DFLL binding for PWM regulator Date: Tue, 4 Dec 2018 17:25:30 +0800 Message-ID: <20181204092548.3038-2-josephl@nvidia.com> References: <20181204092548.3038-1-josephl@nvidia.com> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <20181204092548.3038-1-josephl@nvidia.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: "linux-arm-kernel" Errors-To: linux-arm-kernel-bounces+linux-arm-kernel=m.gmane.org@lists.infradead.org To: Thierry Reding , Peter De Schrijver , Jonathan Hunter Cc: linux-tegra@vger.kernel.org, devicetree@vger.kernel.org, linux-clk@vger.kernel.org, linux-arm-kernel@lists.infradead.org, Joseph Lo List-Id: devicetree@vger.kernel.org From: Peter De Schrijver Add new properties to configure the DFLL PWM regulator support. Also add an example and make the I2C clock only required when I2C support is used. Cc: devicetree@vger.kernel.org Signed-off-by: Peter De Schrijver Signed-off-by: Joseph Lo --- .../bindings/clock/nvidia,tegra124-dfll.txt | 73 ++++++++++++++++++- 1 file changed, 71 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt b/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt index dff236f524a7..8c97600d2bad 100644 --- a/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt +++ b/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt @@ -8,7 +8,6 @@ the fast CPU cluster. It consists of a free-running voltage controlled oscillator connected to the CPU voltage rail (VDD_CPU), and a closed loop control module that will automatically adjust the VDD_CPU voltage by communicating with an off-chip PMIC either via an I2C bus or via PWM signals. -Currently only the I2C mode is supported by these bindings. Required properties: - compatible : should be "nvidia,tegra124-dfll" @@ -45,10 +44,28 @@ Required properties for the control loop parameters: Optional properties for the control loop parameters: - nvidia,cg-scale: Boolean value, see the field DFLL_PARAMS_CG_SCALE in the TRM. +Optional properties for mode selection: +- nvidia,pwm-to-pmic: Use PWM to control regulator rather then I2C. + Required properties for I2C mode: - nvidia,i2c-fs-rate: I2C transfer rate, if using full speed mode. -Example: +Required properties for PWM mode: +- nvidia,pwm-period: period of PWM square wave in microseconds. +- nvidia,init-uv: Regulator voltage in micro volts when PWM control is disabled. +- nvidia,align-offset-uv: Regulator voltage in micro volts when PWM control is + enabled and PWM output is low. +- nvidia,align-step-uv: Voltage increase in micro volts corresponding to a + 1/33th increase in duty cycle. Eg the voltage for 2/33th + duty cycle would be: + nvidia,align-offset-uv + nvidia,align-step-uv * 2. +- pinctrl-0: I/O pad configuration when PWM control is enabled. +- pinctrl-1: I/O pad configuration when PWM control is disabled. +- pinctrl-names: must include the following entries: + - dvfs_pwm_enable: I/O pad configuration when PWM control is enabled. + - dvfs_pwm_disable: I/O pad configuration when PWM control is disabled. + +Example for I2C: clock@70110000 { compatible = "nvidia,tegra124-dfll"; @@ -76,3 +93,55 @@ clock@70110000 { nvidia,i2c-fs-rate = <400000>; }; + +Example for PWM: + +clock@70110000 { + compatible = "nvidia,tegra124-dfll"; + reg = <0 0x70110000 0 0x100>, /* DFLL control */ + <0 0x70110000 0 0x100>, /* I2C output control */ + <0 0x70110100 0 0x100>, /* Integrated I2C controller */ + <0 0x70110200 0 0x100>; /* Look-up table RAM */ + interrupts = ; + clocks = <&tegra_car TEGRA210_CLK_DFLL_SOC>, + <&tegra_car TEGRA210_CLK_DFLL_REF>, + <&tegra_car TEGRA124_CLK_I2C5>;; + clock-names = "soc", "ref", "i2c"; + resets = <&tegra_car TEGRA124_RST_DFLL_DVCO>; + reset-names = "dvco"; + #clock-cells = <0>; + clock-output-names = "dfllCPU_out"; + nvidia,pwm-to-pmic; + nvidia,init-uv = <1000000>; + nvidia,align-step-uv = <19200>; /* 19.2mV */ + nvidia,align-offset-uv = <708000>; /* 708mV */ + nvidia,sample-rate = <25000>; + nvidia,droop-ctrl = <0x00000f00>; + nvidia,force-mode = <1>; + nvidia,cf = <6>; + nvidia,ci = <0>; + nvidia,cg = <2>; + nvidia,pwm-period = <2500>; /* 2.5us */ + pinctrl-names = "dvfs_pwm_enable", "dvfs_pwm_disable"; + pinctrl-0 = <&dvfs_pwm_active_state>; + pinctrl-1 = <&dvfs_pwm_inactive_state>; +}; + +/* pinmux nodes added for completeness. Binding doc can be found in: + * Documentation/devicetree/bindings/pinctrl/nvidia,tegra210-pinmux.txt + */ + +pinmux: pinmux@700008d4 { + dvfs_pwm_active_state: dvfs_pwm_active { + dvfs_pwm_pbb1 { + nvidia,pins = "dvfs_pwm_pbb1"; + nvidia,tristate = ; + }; + }; + dvfs_pwm_inactive_state: dvfs_pwm_inactive { + dvfs_pwm_pbb1 { + nvidia,pins = "dvfs_pwm_pbb1"; + nvidia,tristate = ; + }; + }; +}; -- 2.19.2