From mboxrd@z Thu Jan 1 00:00:00 1970 From: Brian Masney Subject: [PATCH v5 10/14] arm64: dts: qcom: pm8005: add interrupt controller properties Date: Wed, 16 Jan 2019 19:32:30 -0500 Message-ID: <20190117003234.22127-11-masneyb@onstation.org> References: <20190117003234.22127-1-masneyb@onstation.org> Return-path: In-Reply-To: <20190117003234.22127-1-masneyb@onstation.org> Sender: linux-kernel-owner@vger.kernel.org To: linus.walleij@linaro.org, sboyd@kernel.org, bjorn.andersson@linaro.org, andy.gross@linaro.org Cc: marc.zyngier@arm.com, shawnguo@kernel.org, dianders@chromium.org, linux-gpio@vger.kernel.org, nicolas.dechesne@linaro.org, niklas.cassel@linaro.org, david.brown@linaro.org, robh+dt@kernel.org, mark.rutland@arm.com, thierry.reding@gmail.com, linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org, devicetree@vger.kernel.org List-Id: devicetree@vger.kernel.org Add interrupt controller properties now that spmi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney Reviewed-by: Stephen Boyd Reviewed-by: Bjorn Andersson --- Changes since v4: - None Patch introduced in v4. arch/arm64/boot/dts/qcom/pm8005.dtsi | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/pm8005.dtsi b/arch/arm64/boot/dts/qcom/pm8005.dtsi index 4d5aca3eeb69..c0ddf128136c 100644 --- a/arch/arm64/boot/dts/qcom/pm8005.dtsi +++ b/arch/arm64/boot/dts/qcom/pm8005.dtsi @@ -16,10 +16,8 @@ reg = <0xc000>; gpio-controller; #gpio-cells = <2>; - interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, - <0 0xc1 0 IRQ_TYPE_NONE>, - <0 0xc2 0 IRQ_TYPE_NONE>, - <0 0xc3 0 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; }; }; -- 2.17.2