Re: [PATCH 1/2] dt-bindings: extcon: Add support for fsa9480 switch

[Rob Herring <robh@kernel.org>]

On Mon, Feb 25, 2019 at 05:58:21PM +0100, Paweł Chmiel wrote:
> From: Tomasz Figa <tomasz.figa@gmail.com>
> 
> This patch adds documentation for binding of extcont Fairchild
> Semiconductor FSA9480 microusb switch.
> This usb port accessory detector and switch, can be found for example in
> some Samsung s5pv210 based phones.
> 
> Signed-off-by: Tomasz Figa <tomasz.figa@gmail.com>
> Signed-off-by: Paweł Chmiel <pawel.mikolaj.chmiel@gmail.com>
> ---
>  .../bindings/extcon/extcon-fsa9480.txt        | 21 +++++++++++++++++++
>  1 file changed, 21 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt
> 
> diff --git a/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt
> new file mode 100644
> index 000000000000..ebced7b18eb5
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt
> @@ -0,0 +1,21 @@
> +FAIRCHILD SEMICONDUCTOR FSA9480 MICROUSB SWITCH
> +
> +The FSA9480 is a USB port accessory detector and switch. The FSA9480 is fully
> +controlled using I2C and enables USB data, stereo and mono audio, video,
> +microphone, and UART data to use a common connector port.
> +
> +Required properties:
> + - compatible : Must be "fcs,fsa9480"
> + - reg : Specifies i2c slave address. Must be 0x25.
> + - interrupt-parent : Phandle to interrupt controller to which interrupt
> +   signal of the chip is connected.

Remove this as it is implicit.

> + - interrupts : Should contain one entry specifying interrupt signal of
> +   interrupt parent to which interrupt pin of the chip is connected.
> +
> + Example:
> +	musb@25 {
> +		compatible = "fcs,fsa9480";
> +		reg = <0x25>;
> +		interrupt-parent = <&gph2>;
> +		interrupts = <7 0>;
> +	};
> \ No newline at end of file

Fix this.

> -- 
> 2.17.1
>