From mboxrd@z Thu Jan 1 00:00:00 1970 From: Rob Herring Subject: Re: [PATCH 1/2] dt-bindings: extcon: Add support for fsa9480 switch Date: Tue, 26 Mar 2019 09:57:42 -0500 Message-ID: <20190326145742.GA21883@bogus> References: <20190225165822.2770-1-pawel.mikolaj.chmiel@gmail.com> <20190225165822.2770-2-pawel.mikolaj.chmiel@gmail.com> Mime-Version: 1.0 Content-Type: text/plain; charset=utf-8 Content-Transfer-Encoding: 8bit Return-path: Content-Disposition: inline In-Reply-To: <20190225165822.2770-2-pawel.mikolaj.chmiel@gmail.com> Sender: linux-kernel-owner@vger.kernel.org To: =?utf-8?B?UGF3ZcWC?= Chmiel Cc: myungjoo.ham@samsung.com, cw00.choi@samsung.com, mark.rutland@arm.com, linux-kernel@vger.kernel.org, devicetree@vger.kernel.org, Tomasz Figa List-Id: devicetree@vger.kernel.org On Mon, Feb 25, 2019 at 05:58:21PM +0100, Paweł Chmiel wrote: > From: Tomasz Figa > > This patch adds documentation for binding of extcont Fairchild > Semiconductor FSA9480 microusb switch. > This usb port accessory detector and switch, can be found for example in > some Samsung s5pv210 based phones. > > Signed-off-by: Tomasz Figa > Signed-off-by: Paweł Chmiel > --- > .../bindings/extcon/extcon-fsa9480.txt | 21 +++++++++++++++++++ > 1 file changed, 21 insertions(+) > create mode 100644 Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > > diff --git a/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > new file mode 100644 > index 000000000000..ebced7b18eb5 > --- /dev/null > +++ b/Documentation/devicetree/bindings/extcon/extcon-fsa9480.txt > @@ -0,0 +1,21 @@ > +FAIRCHILD SEMICONDUCTOR FSA9480 MICROUSB SWITCH > + > +The FSA9480 is a USB port accessory detector and switch. The FSA9480 is fully > +controlled using I2C and enables USB data, stereo and mono audio, video, > +microphone, and UART data to use a common connector port. > + > +Required properties: > + - compatible : Must be "fcs,fsa9480" > + - reg : Specifies i2c slave address. Must be 0x25. > + - interrupt-parent : Phandle to interrupt controller to which interrupt > + signal of the chip is connected. Remove this as it is implicit. > + - interrupts : Should contain one entry specifying interrupt signal of > + interrupt parent to which interrupt pin of the chip is connected. > + > + Example: > + musb@25 { > + compatible = "fcs,fsa9480"; > + reg = <0x25>; > + interrupt-parent = <&gph2>; > + interrupts = <7 0>; > + }; > \ No newline at end of file Fix this. > -- > 2.17.1 >